Standard Practice for Rapid Indentation Hardness Testing of Metallic Materials

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

04-01-2017

Publisher

American Society for Testing and Materials

This practice covers a procedure for rapid indentation hardness testing of metallic materials.

1.1This practice covers a procedure for rapid indentation hardness testing of metallic materials.

1.2This practice includes additional requirements in Annex A1 for the direct, indirect, and daily verification of rapid indentation hardness testing machines.

1.3The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	E 28
DocumentType	Standard Practice
Pages	5
PublisherName	American Society for Testing and Materials
Status	Current
Supersedes	ASTM E 103 : 2012

ASTM E 10 : 2023	Standard Test Method for Brinell Hardness of Metallic Materials
ASTM E 10 : 2001	Standard Test Method for Brinell Hardness of Metallic Materials
ASTM E 10 : 2018	Standard Test Method for Brinell Hardness of Metallic Materials