• There are no items in your cart

ASTM E 1545 : 2000

Superseded
Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

Standard Test Method for Assignment of the Glass Transition Temperature by Thermomechanical Analysis
Available format(s)

Hardcopy , PDF

Superseded date

11-11-2014

Language(s)

English

Published date

03-10-2000

1.1 This test method covers procedures for the assignment of the glass transition temperature of materials on heating using thermomechanical measurements under prescribed experimental conditions.

1.2 This test method is applicable to amorphous or to partially crystalline materials that are sufficiently rigid below the glass transition to inhibit indentation by the sensing probe.

1.3 The normal operating temperature range is from -100 to 600°C. This temperature range may be extended depending upon the instrumentation used.

1.4 Computer- or electronic-based instruments, techniques, or data treatment equivalent to this test method may also be used. Users of this test method are expressly advised that all such instruments or techniques may not be equivalent. It is the responsibility of the user of this test method to determine the necessary equivalency prior to use. In the case of dispute, only the manual procedures are to be considered valid.

1.5 The values stated in SI units are to be regarded as the standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 7.

Committee
E 37
DocumentType
Test Method
Pages
4
PublisherName
American Society for Testing and Materials
Status
Superseded
SupersededBy

ASTM D 1676 : 2017 Standard Test Methods for Film-Insulated Magnet Wire
ASTM E 1824 : 2018 Standard Test Method for Assignment of a Glass Transition Temperature Using Thermomechanical Analysis: Tension Method
ASTM D 3794 : 2018 Standard Guide for Testing Coil Coatings
ASTM E 2602 : 2009 : R2015 Standard Test Methods for the Assignment of the Glass Transition Temperature by Modulated Temperature Differential Scanning Calorimetry
ASTM E 1640 : 2018 Standard Test Method for Assignment of the Glass Transition Temperature By Dynamic Mechanical Analysis

View more information
US$66.00
Excluding Tax where applicable

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.