• There are no items in your cart

ASTM E 1782 : 2014 : REDLINE

Superseded
Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

Standard Test Method for Determining Vapor Pressure by Thermal Analysis
Available format(s)

PDF

Superseded date

08-23-2022

Language(s)

English

Published date

04-09-2014

CONTAINED IN VOL. 14.02, 2015 Specifies a procedure for the determination of the vapor pressure of pure liquids or melts from boiling point measurements made using differential thermal analysis (DTA) or differential scanning calorimetry (DSC) instrumentation operated at different applied pressures.

1.1This test method describes a procedure for the determination of the vapor pressure of pure liquids or melts from boiling point measurements made using differential thermal analysis (DTA) or differential scanning calorimetry (DSC) instrumentation operated at different applied pressures.

1.2This test method may be used for the temperature range 273 to 773 K (0 to 500°C) and for pressures between 0.2 kPa to 2 MPa. These ranges may differ depending upon the instrumentation used and the thermal stability of materials tested. Because a range of applied pressures is required by this test method, the analyst is best served by use of instrumentation referred to as high pressure differential thermal instrumentation (HPDSC or HPDTA).

1.3The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. (See also IEEE/ASTM SI 10.)

1.4There is no ISO standard equivalent to this test method.

1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Committee
E 37
DocumentType
Redline
Pages
7
PublisherName
American Society for Testing and Materials
Status
Superseded
SupersededBy

ASTM E 1194 : 2017 Standard Test Method for Vapor Pressure
ASTM E 2071 : 2000 : R2010 Standard Practice for Calculating Heat of Vaporization or Sublimation from Vapor Pressure Data
ASTM E 2071 : 2000 : R2015 Standard Practice for Calculating Heat of Vaporization or Sublimation from Vapor Pressure Data
ASTM E 2071 : 2000 : R2005 Standard Practice for Calculating Heat of Vaporization or Sublimation from Vapor Pressure Data
ASTM E 2071 : 2000 Standard Practice for Calculating Heat of Vaporization or Sublimation from Vapor Pressure Data

ASTM E 177 : 2014 : REDLINE Standard Practice for Use of the Terms Precision and Bias in ASTM Test Methods
IEEE/ASTM SI_10-2010 American National Standard for Metric Practice
ASTM E 1142 : 2015 : REDLINE Standard Terminology Relating to Thermophysical Properties
ASTM E 473 : 2016-05 TERMINOLOGY RELATING TO THERMAL ANALYSIS AND RHEOLOGY

View more information
US$75.00
Excluding Tax where applicable

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.