ASTM F 2321 : 2023

1.1This specification covers the manufacture and testing of flexible insulated temporary By-Pass jumpers (By-Pass jumpers) used on energized power lines and equipment.

1.2It is common practice for the user of this protective equipment to prepare complete instructions and safety regulations to govern in detail the correct and safe use of such equipment. Also see 4.2.

1.3The use and maintenance of this equipment are beyond the scope of this specification.

1.4This specification for a system of By-Pass jumpers is covered in four parts as follows:

1.5Each of the four parts is an entity of itself, but is listed as a part of the system for completeness and clarification.

1.6The values stated in SI units are to be regarded as the standard. See IEEE/ASTM SI 10.

1.7The following precautionary caveat pertains only to the test method portions, Sections 13, 26, 48, and 55 of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.8This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.