ASTM F 2811 : 2015
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Standard Test Methods for Evaluating Design and Performance Characteristics of Elliptical Trainers
Hardcopy , PDF
02-01-2021
English
02-09-2016
1.1These test methods specify procedures and equipment used for testing and evaluating elliptical trainers for compliance to Specification F2810. Both design and operational parameters will be evaluated. Where possible and applicable, accepted test methods from other recognized bodies will be used and referenced. In case of a conflict between this document and Specification F2810, Specification F2810 takes precedence.
1.2Requirements—An elliptical trainer is to be tested for all of the following parameters:
1.2.1Endurance,
1.2.2Static loading,
1.2.2.1Handlebars
1.2.2.2Foot supports
1.2.3Adjustable guide systems,
1.2.4Control panel,
1.2.5Warnings, and
1.2.6Documentation.
1.3This test method2 contains additional requirements to address the accessibility of the equipment for persons with disabilities.
1.4The values stated in SI units are to be regarded as the standard. The values in parenthesis are for information only.
1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.