Standard Specification for Screws, Alloy Steel, Heat Treated, 170 ksi and 1170 MPa Minimum Tensile Strength (Inch and Metric)

Available format(s)

PDF

Language(s)

English

Published date

06-01-2017

Publisher

American Society for Testing and Materials

CONTAINED IN VOL. 01.08, 2017 Defines the requirements for quenched and tempered alloy steel screws 0.060 through 1[1/2] in. and 1.6 through 48 mm in diameter having a minimum ultimate tensile strength of 170 KSI or 1170 MPa.

1.1This specification covers the requirements for quenched and tempered alloy steel screws 0.060 through 1¹/₂in. and 1.6 through 48 mm in diameter having a minimum ultimate tensile strength of 170 KSI or 1170 MPa.

1.2The values are stated in inch-pound units for inch fasteners and SI metric units for metric fasteners. The values stated in each system may not be exact equivalents; therefore each system shall be used independently of the other. Combining values from the two systems may result in non-conformance to the standard.

1.3The following hazard caveat pertains only to the test method portion, Section 10, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	F 16
DevelopmentNote	Supersedes ASME F 2882 & ASME F 2882M. (07/2017)
DocumentType	Redline
Pages	8
PublisherName	American Society for Testing and Materials
Status	Current
Supersedes	ASTM F 2882M : 2012 ASTM F 2882 : 2012

ASME B18.2.5M : 2013	METRIC 12-POINT FLANGE HEAD SCREWS
ASME B18.2.1 : 2012	SQUARE, HEX, HEAVY HEX, AND ASKEW HEAD BOLTS AND HEX, HEAVY HEX, HEX FLANGE, LOBED HEAD, AND LAG SCREWS (INCH SERIES)
ASTM F 2328M : 2017 : REDLINE	Standard Test Method for Determining Decarburization and Carburization in Hardened and Tempered Threaded Steel Bolts, Screws, Studs, and Nuts (Metric)
ASTM F 606/F606M : 2016 : REDLINE	Standard Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, Direct Tension Indicators, and Rivets
ASTM F 2328 : 2017 : REDLINE	Standard Test Method for Determining Decarburization and Carburization in Hardened and Tempered Threaded Steel Bolts, Screws, Studs, and Nuts
ASME B18.3 : 2012	SOCKET CAP, SHOULDER, SET SCREWS, AND HEX KEYS (INCH SERIES)
ASME B18.24 : 2015	PART IDENTIFYING NUMBER (PIN) CODE SYSTEM STANDARD FOR B18 FASTENER PRODUCTS
ASME B18.2.7.1M : 2002(R2007)	METRIC 12-SPLINE FLANGE SCREWS