Standard Test Method for Determination of Frictional Torque and Friction Factor for Hip Replacement Bearings under Standard Conditions Using a Reciprocal Friction Simulator

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

11-16-2020

Publisher

American Society for Testing and Materials

1.1This test procedure provides a method of determining the frictional torque and friction factor of artificial hip joint bearings used in total hip replacement (THR) systems under laboratory conditions using a reciprocal friction simulator. This test method specifies the angular movement between the articulating components, the pattern of applied force, and the way data can be measured and analyzed.

1.2Many variables can be investigated using this test method including, but not limited to, the effect of head size, different inclination/version angles, different deformation levels of the acetabular cup, bearing clearances, lubrication, scratched heads, and artificial ageing.

1.3The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	F 04
DocumentType	Test Method
Pages	9
PublisherName	American Society for Testing and Materials
Status	Current

ASTM F 86 : 2013	Standard Practice for Surface Preparation and Marking of Metallic Surgical Implants
ASTM E 122 : 2017 : R2022	Standard Practice for Calculating Sample Size to Estimate, With Specified Precision, the Average for a Characteristic of a Lot or Process
ASTM E 122 : 2017	Standard Practice for Calculating Sample Size to Estimate, With Specified Precision, the Average for a Characteristic of a Lot or Process
ASTM E 4 : 2021	Standard Practices for Force Calibration and Verification of Testing Machines
ASTM F 86 : 2021	Standard Practice for Surface Preparation and Marking of Metallic Surgical Implants