Standard Practice for Evaluating the Quality of Molded Poly(Vinyl Chloride) (PVC) Plastic Pipe Fittings by the Heat Reversion Technique

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

04-21-2021

Publisher

American Society for Testing and Materials

1.1This practice covers a procedure for evaluating the quality of molded poly(vinyl chloride) (PVC) plastic pipe fittings after exposure to heat.

1.2Units—The values stated in either inch-pound or SI units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

Note 1:The values in square brackets are SI units requirements.

1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	F 17
DocumentType	Standard Practice
Pages	5
PublisherName	American Society for Testing and Materials
Status	Current
Supersedes	ASTM F 610/F610M : 2015

ASTM F 1336 : 2020	Standard Specification for Poly(Vinyl Chloride) (PVC) Gasketed Sewer Fittings
ANSI/AWWA C907:2023	Injection-Molded Polyvinyl Chloride (PVC) Pressure Fittings, 4 In. Through 12In. (100mm Through 300 mm)