• There are no items in your cart

ATIS T1.403 : 99 SUPP B 2002

Superseded
Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

NETWORK AND CUSTOMER INSTALLATION INTERFACES - DS1 - ELECTRICAL INTERFACE
Superseded date

07-23-2013

Published date

01-12-2013

Foreword
1 Scope
2 Normative references
3 Definitions, Abbreviations and Acronyms
4 General information
5 Electrical specifications
6 Receiver impedance and return loss
7 Framing formats
8 DSI application
9 Maintenance
10 Connector arrangements
Table 1 - Requirements for reference signals
Table 2 - Superframe format
Table 3 - Extended superframe format
Table 4 - Assigned bit-patterned ESF data link messages
Table 5 - Unassigned ESF data link messages
Table 6 - Example of performance report messages
Figure 1 - Network interface
Figure 2 - Isolated pulse template and corner points
Figure 3 - Pulse amplitude envelope with 60 Hz longitudinal
           currents
Figure 4 - Frequency weighting functions for jitter
           specifications
Figure 5 - Bit assignments
Figure 6 - Performance report message structure and contents
Figure 7 - Customer Installation Loopbacks
Figure 8 - Longitudinal balance measuring circuitry
Figure 9 - Connector pin assignments (8-position RJ48C)
Figure 10 - Connector pin assignments (8-position RJ48X with
            shorting bars)
Figure 11 - Connector pin assignments (50-position RJ48M)
Figure 12 - Connector pin assignments (50-position RJ48H)
Annex A - Path and test signal identification message
          requirements
Annex B - In-band signaling for fractional-TI (FTI) channel
          loopbacks
Annex C - DSI idle signal
Annex D - AIS-CI and RAI-CI
Annex E - Supplementary Performance Report Message (SPRM)
Annex F - Network Performance Report Message (NPRM)
Annex G - Cable Characteristics
Annex H - Line Build-Out
Annex I - ESF Data Link Message Comparison With Other
          Standards
Annex J - Alarm Indication Signal
Annex K - Bibliography

Addresses the requirements for a DS1 carrier to customer installation DS1 metallic interface, referred to as the network interface. Requirements include electrical characteristics, format parameters and physical characteristics at the interface. The signals at the NI that are described in this standard are of two types: normal operating signals; maintenance signals. A 4-wire DS1 interface based on the various metallic digital facilities currently in use and covered in this standard.

Committee
NIPP
DevelopmentNote
Redesignated as ATIS 0600403. (03/2010)
DocumentType
Standard
PublisherName
Alliance for Telecommunications Industry Solutions
Status
Superseded
SupersededBy

Standards Relationship
CSA T538 : M92 Identical

PD IEC/TR 61850-90-12:2015 Communication networks and systems for power utility automation Wide area network engineering guidelines
TS 103 161-15 : 1.1.1 ACCESS, TERMINALS, TRANSMISSION AND MULTIPLEXING (ATTM); INTEGRATED BROADBAND CABLE AND TELEVISION NETWORKS; IPCABLECOM 1.5; PART 15: ANALOG TRUNKING FOR PBX SPECIFICATION
TR TSV 001062 : ISSUE 1 GENERIC REQUIREMENTS FOR PHASE 1 SMDS CUSTOMER NETWORK MANAGEMENT SERVICE
FIPS PUB 146-1 : NOTICE 1 GOVERNMENT OPEN SYSTEMS INTERCONNECTION PROFILE (GOSIP)
GR 828 CORE : ISSUE 1 REV 2 OPERATIONS TECHNOLOGY GENERIC REQUIREMENTS (OTGR): GENERIC OPERATIONS INTERFACE - OSI COMMUNICATIONS ARCHITECTURE
TIA/EIA 634 : B1999 MSC-BS INTERFACE FOR PUBLIC WIRELESS COMMUNICATIONS SYSTEMS
TS 100 588 : 8.0.1 DIGITAL CELLULAR TELECOMMUNICATIONS SYSTEM (PHASE 2+); BASE STATION SYSTEM - MOBILE SERVICES SWITCHING CENTRE (BSS-MSC) INTERFACE LAYER 1 SPECIFICATION
GR 1117 CORE : ISSUE 1 GENERIC REQUIREMENTS FOR EXCHANGE PVC CRS CNM SERVICE
SR 3887 : ISSUE 1 REV 1 1997 VERSION OF NATIONAL ISDN PRIMARY RATE INTERFACE CUSTOMER PREMISES EQUIPMENT GENERIC GUIDELINES
TR TSV 000773 : ISSUE 1 REV 1 LOCAL ACCESS SYSTEM GENERIC REQUIREMENTS, OBJECTIVES AND INTERFACES IN SUPPORT OF SWITCHED MULTI-MEGABIT DATA SERVICE
SCTE 136-2 : 2013 CABLE MODEM TDM EMULATION INTERFACE STANDARD
GR 2878 CORE : ISSUE 4 GENERIC REQUIREMENTS FOR CCS NODES SUPPORTING ATM HIGH-SPEED SIGNALING LINKS (HSLS)
TS 101 298 : 8.0.1 DIGITAL CELLULAR TELECOMMUNICATIONS SYSTEM (PHASE 2+); GENERAL PACKET RADIO SERVICE (GPRS); BASE STATION SYSTEM (BSS) - SERVING GPRS SUPPORT NODE (SGSN) INTERFACE; GB INTERFACE LAYER 1
ATIS T1.403.02 : 99(R2005) NETWORK AND CUSTOMER INSTALLATION INTERFACES - DS1 ROBBED-BIT SIGNALLING STATE DEFINITIONS
SCTE 165-11 : 2009 IPCABLECOM 1.5 - PART 11: ANALOG TRUNKING FOR PBX SPECIFICATION
NASA CCSDS 766.2-B : ISSUE 1 VOICE AND AUDIO COMMUNICATIONS
GR 1113 CORE : ISSUE 1 ASYNCHRONOUS TRANSFER MODE (ATM) AND ATM ADAPTATION LAYER (AAL) PROTOCOLS
TIA 464 : C2002(R2009) TELECOMMUNICATIONS - MULTILINE TERMINAL SYSTEMS - REQUIREMENTS FOR PBXSWITCHING EQUIPMENT
TIA 594 : B2004(R2009) TELECOMMUNICATIONS - MULTILINE TERMINAL SYSTEMS - SYNCHRONOUS METHODS AND TECHNICAL REQUIREMENTS FOR PRIVATE INTEGRATED SERVICES NETWORKS

ATIS T1.102 : 93(R1999) DIGITAL HIERARCHY - ELECTRICAL INTERFACES
ATIS T1.646 : 2003 NETWORK AND CUSTOMER INSTALLATION INTERFACES - BROADBAND ISDN: COMMON CRITERIA
ATIS T1.231 : 2003 LAYER 1 IN-SERVICE DIGITAL TRANSMISSION PERFORMANCE MONITORING

View more information
Sorry this product is not available in your region.

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.