BS 4311-3:1993
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Hardcopy , PDF
08-31-2007
English
04-15-1993
Committees responsible
Foreword
Specification
1. Scope
2. References
3. Definitions and nomenclature
4. Verification
4.1 Frequency of recalibration
4.2 Measuring faces
4.3 Calibration
4.4 Grading
5. Case
5.1 Maintenance
5.2 Marking
6. Documentation
7. Accuracy
7.1 Requirements
7.2 Excluded border zone
7.3 Length tolerances for used gauge blocks
8. Gauge blocks in inch units
Annexes
A. (informative) Care of gauge blocks
A.1 General care
A.2 Preparation before use
A.3 Care in use
A.4 Wringing
A.5 Damaged gauge blocks
A.6 Care after use
B. (informative) Wear in use and maintenance of gauge
blocks
B.1 Wear in use
B.2 Restoration of wringing property
B.3 Designated grade after servicing
C. (informative) Selecting grade of gauge blocks
Tables
1. Length tolerances for used metric gauge blocks
2. Length tolerances for used inch gauge blocks
List of references
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.