BS 7675:1993

Committees responsible
National foreword
Specification
1 Scope
2 Normative references
3 Definitions
4 Symbols
5 Purpose of checking
6 Checking methods
7 Choice and designation of checking method
8 Measuring equipment
9 Measuring equipment requirements
10 Gauging tools for establishing the datum
11 Checking block requirements
12 Master shell and comparison shell requirements
13 Correction factors
14 Typical checking procedures
15 Condition of the half-bearings to be checked
16 Measuring errors
17 Accuracy of methods used
18 Specifications on bearing drawings
19 Specifications for the control of the checking
     means
Annexes
A (normative) Determination of the correction factor
     of the master checking block - Method A
B (normative) Determination of the correction factor
     of the master checking block - Method B
C (normative) Determination of the correction factor
     of the series checking block used alone
D (normative) Determination of the correction factor
     of the master shell of comparison shell
E (normative) Tests and calculations of
     repeatability, reproducibility and comparability
Figures
1 Nip, a
2 Principle of method A
3 Principle of method B
4 Typical measuring equipment with one column, for
     method A
5 Typical measuring equipment with two columns, for
     method B
6 Checking block
7 Master shell
8 Stepped master shell not suitable for checking
     bearings of uniform wall thickness
A.1 Untitled
A.2 Untitled
A.3 Untitled
B.1 Untitled
B.2 Untitled
B.3 Untitled