BS 903-C5:1992
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Physical testing of rubber Determination of insulation resistance
Hardcopy , PDF
04-30-2016
English
08-15-1992
Committees responsible
National foreword
Section one. General
1 Scope
2 Definitions
3 Significance
4 Test equipment
Section two. Electrodes
5 Electrodes
6 Taper pin electrodes (for flat plates, tubes and
rods)
7 Conducting paint electrodes (for flat plates; tubes
and rods)
8 Bar electrodes (for thin sheets and tapes)
Section three. Test specimens
9 Test specimens for taper pin electrodes
10 Test specimens for conducting paint electrodes
11 Test specimens for bar electrodes
Section four. Conditioning
12 Conditions and procedures
Section five. Procedure
13 Selection, preparation and measurement
Section six. Expression of results
14 Mathematical treatment
Section seven. Test report
15 Necessary information
Section eight. General principles
16 Selection of test pieces
17 Cleaning test pieces
18 Mounting test specimens
19 Reference
Figures
1 Plate specimens with taper pin electrodes
2 Tube or rod specimens with taper pin electrodes
3 Plate specimen with conducting paint electrodes
4 Tube or rod specimen with conducting paint
electrodes
5 Bar electrodes for tapes or thin sheet material
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.