BS EN 1652:1998

Foreword
1 Scope
2 Normative references
3 Definitions
    3.1 Plate
    3.2 Sheet
    3.3 Strip
    3.4 Circle
4 Designations
    4.1 Material
    4.2 Material condition
    4.3 Product
5 Ordering information
6 Requirements
    6.1 Composition
    6.2 Mechanical properties
    6.3 Grain size
    6.4 Dimensions and tolerances
    6.5 Edgewise curvature c
    6.6 Surface condition
7 Sampling
    7.1 General
    7.2 Analysis
    7.3 Tensile, hardness, grain size and technological
          tests
8 Test methods
    8.1 Analysis
    8.2 Tensile test
    8.3 Hardness test
    8.4 Estimation of average grain size
    8.5 Technological tests
    8.6 Retests
    8.7 Rounding of results
9 Declaration of conformity and inspection of documentation
    9.1 Declaration of conformity
    9.2 Inspection of documentation
10 Marking, packaging, labelling
Annex A (informative) Bibliography
Figure 1 Edgewise curvature c
Table 1 Composition of copper
Table 2 Composition of copper alloys
Table 3 Mechanical properties
Table 4 Tolerances on thickness of hot rolled products
          (plate, sheet, strip and circles)
Table 5 Tolerances on thickness of cold rolled products
          (sheet, strip and circles)
Table 6 Tolerances on width of cold rolled strip
Table 7 Tolerances on width of plate and sheet
Table 8 Tolerances on length of plate, sheet and strip
          cut to length for lengths up to 5000 mm
Table 9 Squareness of cut plate and sheet
Table 10 Tolerances on diameter for circles
Table 11 Edgewise curvature