BS EN 60384-11:2008

1 General
   1.1 Scope
   1.2 Object
   1.3 Normative references
   1.4 Information to be given in a detail specification
        1.4.1 Outline drawing and dimensions
        1.4.2 Mounting
        1.4.3 Ratings and characteristics
        1.4.4 Marking
   1.5 Terms and definitions
   1.6 Marking
2 Preferred ratings and characteristics
   2.1 Preferred characteristics
        2.1.1 Preferred climatic categories
   2.2 Preferred values of ratings
        2.2.1 Rated capacitance (C[R])
        2.2.2 Tolerance on rated capacitance
        2.2.3 Rated voltage (U[R])
        2.2.4 Category voltage (U[C])
        2.2.5 Rated temperature
3 Quality assessment procedures
   3.1 Primary stage of manufacture
   3.2 Structurally similar components
   3.3 Certified records of released lots
   3.4 Qualification approval
        3.4.1 Qualification approval on the basis of the
               fixed sample size procedure
        3.4.2 Tests
   3.5 Quality conformance inspection
        3.5.1 Formation of inspection lots
        3.5.2 Test schedule
        3.5.3 Delayed delivery
        3.5.4 Assessment levels
4 Test and measurement procedures
   4.1 Visual examination and check of dimensions
   4.2 Electrical tests
        4.2.1 Voltage proof
        4.2.2 Capacitance
        4.2.3 Tangent of loss angle (tan delta)
        4.2.4 Insulation resistance
        4.2.5 Characteristics depending on temperature
               (if required in the detail specification)
   4.3 Robustness of terminations
        4.3.1 Initial measurements
   4.4 Resistance to soldering heat
        4.4.1 Conditions
        4.4.2 Final inspection, measurements and requirements
   4.5 Solderability
   4.6 Rapid change of temperature
        4.6.1 Initial measurement
        4.6.2 Number of cycles: 5
   4.7 Vibration
   4.8 Bump
        4.8.1 Initial measurements
        4.8.2 Severities
        4.8.3 Final inspection, measurements and requirements
   4.9 Shock
        4.9.1 Initial measurements
   4.10 Climatic sequence
        4.10.1 Initial measurements
        4.10.2 Dry heat
        4.10.3 Damp heat, cyclic, Test Db, first cycle
        4.10.4 Cold
        4.10.5 Low air pressure
        4.10.6 Damp heat, cyclic, Test Db, remaining cycles
   4.11 Damp heat, steady state
        4.11.1 Initial measurements
   4.12 Endurance
   4.13 Component solvent resistance (if applicable)
   4.14 Solvent resistance of the marking (if applicable)
Annex ZA (normative) - Normative references to international
                       publications with their corresponding
                       European publications
Bibliography