FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
5 General notes on tests
6 Classification
7 Marking
8 Protection against accidental contact with live parts
9 Terminals
10 Provisions for earthing
11 Moisture resistance and insulation
12 Electric strength
13 Thermal endurance test for windings
14 Fault conditions
15 Protection of associated components
16 Abnormal conditions
17 Behaviour of the control gear at end of lamp life
18 Construction
19 Creepage distances and clearances
20 Screws, current-carrying parts and connections
21 Resistance to heat, fire and tracking
22 Resistance to corrosion
Annex A (normative) - Test to establish whether
        a conductive part is a live part whic
        may cause an electric shock
Annex B (normative) - Particular requirements for
        thermally protected lamp control gear
Annex C (normative) - Particular requirements for
        electronic lamp control gear with
        means of protection against overheating
Annex D (normative) - Requirements for carrying out
        the heating tests of thermally protected
        lamp control gear
Annex E (normative) - Use of constant S other than
        4500 in t[w] tests
Annex F (normative) - Draught-proof enclosure
Annex G (normative) - Explanation of the derivation of
        the values of pulse voltages
Annex H (normative) - Tests
Annex I (normative) - Measurement of high-frequency
        leakage current
Annex J (normative) - Particular additional safety
        requirements for a.c., a.c./d.c. or d.c.
        supplied electronic control gear for emergency
        lighting
Annex K (informative) - Components used in the
        asymmetric pulse test circuit
Annex L (normative) - Information for control gear design
Bibliography
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications