Name: BS EN ISO 11296-2:2018
Brand: BSI

Plastics piping systems for renovation of underground non-pressure drainage and sewerage networks Lining with continuous pipes

Published date

03-01-2018

Publisher

British Standards Institution

This document, in conjunction with ISO 11296‑1, specifies requirements and test methods for pipesand fittings which are part of plastics piping systems installed as continuous pipes in the renovation ofunderground non-pressure drainage and sewerage networks. It is applicable to polyethylene (PE) pipesof three different types:— PE solid wall single layered pipes (nominal outside diameter, dn), including any identification stripes;— PE pipes with co-extruded layers on either or both the outside and inside of the pipe (total outsidediameter, dn), as specified in Annex A, where all layers have the same MRS rating;— PE coated pipes (outside diameter, dn) having a peelable, contiguous, thermoplastics additionallayer on the outside of the pipe (“coated pipe”), see Annex A.In addition it covers:— jointing of pipe lengths by means of butt fusion;— fabricated and injection-moulded fittings made of PE.

PE solid wall single layered pipes (nominal outside diameter, d_n), including any identification stripes;
PE pipes with co-extruded layers on either or both the outside and inside of the pipe (total outside diameter, d_n), as specified in AnnexA, where all layers have the same MRS rating;
PE coated pipes (outside diameter, d_n) having a peelable, contiguous, thermoplastics additional layer on the outside of the pipe (“coated pipe”), see AnnexA.

In addition it covers:

jointing of pipe lengths by means of butt fusion;
fabricated and injection-moulded fittings made of PE.

Committee	PRI/88/3
DevelopmentNote	Supersedes BS EN 13566-2 and 16/30315817 DC. (04/2018)
DocumentType	Standard
PublisherName	British Standards Institution
Status	Current
Supersedes	BS EN 13566-2:2005