• There are no items in your cart

BS ISO 16049-2:2020

Current
Current

The latest, up-to-date edition.

Air cargo equipment. Restraint straps Utilization requirements and recommendations and lashing calculations
Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

01-23-2020

This document aims at providing general utilization requirements and recommendations and calculation methods adequate to guarantee the effectiveness and ultimate load strength of tie-down/lashing arrangements performed to restrain cargo on board civil transport aircraft during flight: cargo loaded and tied down onto airworthiness approved air cargo pallets, themselves restrained into aircraft lower deck or main deck or upper deck cargo systems meeting the restraint requirements of air cargo pallets approved in accordance withISO8097(NAS3610) orISO21100, or additional tie-down on aircraft structure when necessitated by pallet maximum gross mass or centre of gravity limits, or non-unitized individual pieces of cargo, or pieces of cargo placed onto an unrestrained (“floating”) pallet into either lower deck, main deck or upper deck containerized cargo compartments of an aircraft, or individual pieces of load loaded in non-containerized (bulk loaded) baggage or cargo compartments.

This document aims at providing general utilization requirements and recommendations and calculation methods adequate to guarantee the effectiveness and ultimate load strength of tie-down/lashing arrangements performed to restrain cargo on board civil transport aircraft during flight: cargo loaded and tied down onto airworthiness approved air cargo pallets, themselves restrained into aircraft lower deck or main deck or upper deck cargo systems meeting the restraint requirements of air cargo pallets approved in accordance with ISO8097 (NAS3610) or ISO21100 , or additional tie-down on aircraft structure when necessitated by pallet maximum gross mass or centre of gravity limits, or non-unitized individual pieces of cargo, or pieces of cargo placed onto an unrestrained (“floating??) pallet into either lower deck, main deck or upper deck containerized cargo compartments of an aircraft, or individual pieces of load loaded in non-containerized (bulk loaded) baggage or cargo compartments. This document applies to cargo tie-down/lashing arrangements using exclusively air cargo restraint straps conforming to ISO16049-1. Its general recommendations may also be used for tie-down arrangements using other means (e.g. steel cables, rope, other types of straps), but under the user’s responsibility as to their adequacy and the strength calculations required. NOTE1 Where tie-down is performed onto aircraft structure as per b) or c) above, additional restrictions can be stated in the aircraft\'s Authority approved Weight and Balance Manual. NOTE2 The use of chains, rods, or other rigid devices for tie-down onto civil transport aircraft floor tracks, which can generate excessive stress in the aircraft structure, is not part of the scope of this document. .This document aims at providing industry recognized means of complying with Airworthiness Authorities general requirements applicable to load securing on board civil transport aircraft (see CCAR-25, JAS Part3, 14 CFR Part25 and EASA CS-25), and aircraft manufacturers Authority approved Weight and Balance Manuals for each aircraft type as specified therein. It is not the intent of this document to specify when restraint straps should be used, but how they should be used.Meeting the methods requirements of this document is not alone sufficient to ensure flight safety: this document is based on the assumption that cargo tie-down will be designed, performed, and checked prior to aircraft departure in accordance with appropriate operating instructions conforming to the Weight and Balance Manual of the aircraft concerned, by competent, suitably trained, personnel as defined for example in ISO9001:2015, 6.2.2 (see Clause8).

Committee
ACE/57
DocumentType
Standard
ISBN
9780580933660
Pages
26
ProductNote
This standard can also refers as SAE AS 5385 D, ISO 21894, SAE ARP 5595B
PublisherName
British Standards Institution
Status
Current
Supersedes

Standards Relationship
ISO 16049-2:2020 Identical

View more information
US$237.18
Excluding Tax where applicable

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.