CSA C108.6 : 0

Technical Committee on Electromagnetic Compatibility of
Radio Frequency Generators, Industrial, Scientific and
Medical
CSA Preface
Foreword
CISPR Preface
1 Scope and Object
2 Definitions
3 Frequencies Designated for ISM Use
4 Classification of ISM Equipment
   4.1 Separation Into Groups
   4.2 Division Into Classes
5 Limits of Electromagnetic Disturbances
   5.1 Limits of Terminal Disturbance Voltage
   5.2 Limits of Electromagnetic Radiation Disturbance
   5.3 Provisions for Protection of Specific Safety
        Services
6 Assessment of Conformity of Equipment
   6.1 Equipment in Series Production
   6.2 Equipment Produced on an Individual Basis
   6.3 Statistical Assessment of Compliance of Series
        Produced Equipment
7 General Measurement Requirements
   7.1 Ambient Noise
   7.2 Measuring Equipment
   7.3 Frequency Measurement
   7.4 Configuration of Equipment Under Test
   7.5 Load Conditions of Equipment Under Test
8 Special Provisions for Test Site Measurements
   (9 kHz to 1 GHz)
   8.1 Radiation Test Site for 9 kHz to 1 GHz
   8.2 Measurement of Mains Terminal Disturbance Voltage
9 Radiation Measurements: 1 GHz to 18 GHz
   9.1 Test Arrangement
   9.2 Receiving Antenna
   9.3 Validation and Calibration of Test Site
   9.4 Measuring Procedure
10 Measurement "In situ"
11 Safety Precautions
Figures
Annexes
A - Examples of Equipment Classification
B - Precautions to be Taken in the Use of a Spectrum
    Analyser
C - Measurement of Electromagnetic Radiation Disturbance
    in the Presence of Signals from Radio Transmitters
D - Propagation of Interference from Industrial RF
    Equipment at Frequencies Between 30 MHz and 300 MHz