Name: DEFSTAN 02-736(PT4)/3(2011) : 2011
Brand: DEFSTAN

REQUIREMENTS FOR Q1 (NAVY) QUALITY STEEL - PART 4: ROLLED SECTIONS

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

08-05-2011

Publisher

UK Ministry of Defence Standards

Foreword
1 Scope
2 Warning
3 Normative References
4 Definitions
5 Abbreviations
6 Materials
7 Manufacture
8 Inspection and Testing
9 Quality Assurance Documentation
10 Identification
11 Maintenance of Route Approval
Annex A - Procedure for Q1(N) Rolled Section Route Approval
Annex B - Procedures for Dynamic Toughness Testing of Q1(N)
Rolled Section During Route Approval
Annex C - Procedure for Thickness Measurement
Annex D - Procurement Check List

Describes requirements for Q1(N) quenched and tempered steel rolled sections.

DevelopmentNote	Supersedes DEFSTAN 02-736(PT4)/2(2004). (11/2011) This standard is obsolescent because it is no longer required for procurement of new equipment but is retained for maintenance purposes in support of existing in-service equipment. (08/2016)
DocumentType	Standard
Pages	38
PublisherName	UK Ministry of Defence Standards
Status	Current
Supersedes	DEFSTAN 02-736(PT4)/2(2004) : 2004

DEFSTAN 02-729(PT5)/3(2013) : 2013

REQUIREMENTS FOR NON-DESTRUCTIVE EXAMINATION METHODS - PART 5: ULTRASONIC

BS EN ISO 148-1:2016	Metallic materials. Charpy pendulum impact test Test method
DEFSTAN 02-729(PT5)/2(2006) : 2006	REQUIREMENTS FOR NON-DESTRUCTIVE EXAMINATION METHODS - PART 5: ULTRASONIC
BS EN 10306:2002	Iron and steel. Ultrasonic testing of H beams with parallel flanges and IPE beams
DEFSTAN 02-773/2(2006) : 2006	MINIMUM NON-DESTRUCTIVE EXAMINATION ACCEPTANCE STANDARDS FOR WELDS IN HM SUBMARINES AND SURFACE SHIPS NOT IN CLASS
BS EN ISO 6892-1:2016	Metallic materials. Tensile testing Method of test at room temperature
DEFSTAN 02-729(PT2)/2(2005) : 2005	REQUIREMENTS FOR NON-DESTRUCTIVE EXAMINATION METHODS IN HM SUBMARINES AND SURFACE SHIPS NOT IN CLASS - PART 2: MAGNETIC PARTICLE
DEFSTAN 02-770(PT1)/3(2010) : 2010	REQUIREMENTS FOR THE WELDING AND FABRICATION OF HIGH STRENGTH STEELS - PART 1: GENERAL
DEFSTAN 02-770(PT2)/3(2010) : 2010	WELDING AND FABRICATION OF HIGH STRENGTH STEELS - PART 2: APPROVAL OF WELDING PROCEDURES FOR SUBMARINE CONSTRUCTION AND UPKEEP
BS 7448-3:2005	Fracture mechanics toughness tests Method for determination of fracture toughness of metallic materials at rates of increase in stress intensity factor greater than 3.0 MPa m0.5 s-1
BS EN ISO 8501-1:2007	Preparation of steel substrates before application of paints and related products. Visual assessment of surface cleanliness Rust grades and preparation grades of uncoated steel substrates and of steel substrates after overall removal of previous coatings