SPECIFICATIONS FOR PARTICULAR TYPES OF WINDING WIRES - PART 0-5: GENERAL REQUIREMENTS - GLASS-FIBRE BRAIDED RESIN OR VARNISH IMPREGNATED, BARE OR ENAMELLED RECTANGULAR COPPER WIRE

Available format(s)

Hardcopy , PDF

Language(s)

German

Published date

01-01-2007

Publisher

German Institute for Standardisation (Deutsches Institut für Normung)

INTRODUCTION
1 Scope
2 Normative references
3 Definitions, general notes on methods of test and
   appearance
   3.1 Definitions
   3.2 General notes on methods of test
   3.3 Appearance
4 Dimensions
   4.1 Conductor dimensions
   4.2 Tolerance on conductor dimensions
   4.3 Rounding of corners
   4.4 Increase in dimensions due to the insulation
   4.5 Overall dimensions
5 Electrical resistance
6 Elongation
7 Springiness
8 Flexibility and adherence
   8.1 Mandrel winding test
   8.2 Adherence test
9 Heat shock
10 Cut-through
11 Resistance to abrasion
12 Resistance to solvents
13 Breakdown voltage
14 Continuity of insulation
15 Temperature index
16 Resistance to refrigerants
17 Solderability
18 Heat or solvent bonding
19 Dielectric dissipation factor
20 Resistance to transformer oil
21 Loss of mass
23 Pin hole test
30 Packaging
Annex A (informative) Nominal cross-sectional areas for
                      preferred and intermediate sizes
Annex ZA (normative) Normative references to international
                     publications with their corresponding
                     European publications

Specifies general requirements of glass-fibre braided resin or varnish impregnated, bare or enamelled rectangular copper wire.

DevelopmentNote	Supersedes DIN IEC 60317-0-5. Applies in conjunction with DIN EN 60851-1 issue 10-2004, DIN EN 60851-2 issue 07-2004, DIN EN 60851-3 issue 07-2004, DIN EN 60851-4 issue 11-2005, DIN EN 60851-5 issue 04-2005, DIN EN 60851-6 issue 10-2004. (09/2007)
DocumentType	Standard
Pages	26
PublisherName	German Institute for Standardisation (Deutsches Institut für Normung)
Status	Current
Supersedes	DIN IEC 60317-0-5:2005-07 (Draft)

Standards	Relationship
IEC 60317-0-5:2006	Identical
I.S. EN 60317-0-5:2007	Identical
SN EN 60317-0-5 : 1994 AMD 2 2000	Identical
UNE-EN 60317-0-5:2007	Identical
BS EN 60317-0-5:2007	Identical
EN 60317-0-5:2007	Identical