EN 2755 : 2009

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements characteristics, inspection and test method
5 Quality assurance
  5.1 Production qualification
  5.2 Acceptance conditions
      5.2.1 Inspection and tests to be carried out by the
            manufacturer
      5.2.2 Purchaser's (user's) quality control
6 Packaging
7 Certificate of compliance
Annex A (normative) - Verification of permissible and
                      ultimate static loads
      A.1 Permissible radial static load (C[s])
          A.1.1 Principle
          A.1.2 Method
      A.2 Ultimate radial static load
          A.2.1 Principle
          A.2.2 Method
      A.3 Permissible axial static load (C[a])
          A.3.1 Principle
          A.3.2 Method
      A.4 Ultimate axial static load
          A.4.1 General
          A.4.2 Principle
          A.4.3 Method
Annex B (normative) - Verification of dynamic radial
                      load (C[25])
      B.1 Principle
      B.2 Method
          B.2.1 Testing at ambient temperature
          B.2.2 Testing at low temperature
          B.2.3 Testing at elevated temperature
      B.4 Test at ambient temperature after immersion
Annex C (normative) - Fluids - Essential characteristics
      C.1 Fuel for turbine aero engine
      C.2 Fluids for de-icing circuit
      C.3 Hydraulic fluids
          C.3.1 Mineral fluid for hydraulic transmission
          C.3.2 Phosphate of ester hydraulic fluid
      C.4 De-icing and anti-icing fluids
Annex D (normative) - Measurement of the peel strength
                      of the liner
      D.1 Principle
      D.2 Method
Annex E (normative) - Simplified qualification procedure
      E.1 Rules for application
          E.1.1 General
      E.2 Choice of references
      E.3 Rules for qualification
      E.4 Plain bearing distribution