EN 300 341-1 : 1.3.1

Intellectual Property Rights
Foreword
Introduction
1 Scope
2 References
3 Definitions, symbols and abbreviations
   3.1 Definitions
   3.2 Symbols
   3.3 Abbreviations
4 General
   4.1 Presentation of equipment for testing purposes
   4.2 Mechanical and electrical design
   4.3 Interpretation of the measurement results
5 Technical characteristics
   5.1 Transmitter parameter limits
   5.2 Receiver parameter limits
6 Test conditions, power sources and ambient
   temperatures
   6.1 Normal and extreme test conditions
   6.2 Test power source
   6.3 Normal test conditions
   6.4 Extreme test conditions
   6.5 Procedure for tests at extreme temperatures
7 General conditions
   7.1 Normal test signals, test conditions and the
        unwanted test signalsrange is a subset of the
        total operating frequency range
   7.2 Artificial antenna
   7.3 Test sites and general arrangements for radiated
        measurements
   7.4 Transmitter automatic shut-off facility
   7.5 Modes of operation of the transmitter
   7.6 Arrangements for test signals at the input of
        the receiver via a test fixture or a test antenna
   7.7 Receiver mute or squelch facility
   7.8 Encoder for receiver measurements
   7.9 Facilities for access between the receiver
        demodulator output and its decoder
   7.10 Calling indicator
   7.11 Reset
   7.12 Reset time
8 Method of measurements for transmitter parameters
   8.1 Frequency error
   8.2 Effective radiated power
   8.3 Adjacent channel power
   8.4 Radiated spurious emissions
   8.5 Transient frequency behaviour of the transmitter
9 Methods of measurement for receiver parameters
   9.1 Average usable sensitivity (field strength,
        responses)
   9.2 Co-channel rejection
   9.3 Adjacent channel selectivity
   9.4 Spurious response rejection
   9.5 Intermodulation response rejection
   9.6 Blocking or desensitization
   9.7 Receiver Spurious radiations
10 Measurement uncertainty
Annex A (normative): Radiated measurement
      A.1 Test sites and general arrangements for
          measurements involving the use of radiated
          fields
      A.2 Guidance on the use of radiated emissions
          test sites
      A.3 Coupling of signals
      A.4 Standard test position
      A.5 Test fixture
Annex B (normative): Specifications for adjacent
        channel power measurement arrangements
      B.1 Power measuring receiver specification
Annex C (normative): Graphical representation of
        the selection of equipment and frequencies
        for testing
      C.1 Tests on a single sample
      C.2 Tests and samples needed when the switching
          range is a subset of the alignment range
      C.3 Tests and samples for a family of equipment
          where the alignment range is a subset of the
          total operating frequency range
Bibliography
History