EN 301 357-1 : 1.4.1
Current
The latest, up-to-date edition.
ELECTROMAGNETIC COMPATIBILITY AND RADIO SPECTRUM MATTERS (ERM); CORDLESS AUDIO DEVICES IN THE RANGE 25 MHZ TO 2000 MHZ; PART 1: TECHNICAL CHARACTERISTICS AND TEST METHODS
Hardcopy , PDF
English
Intellectual Property Rights
Foreword
Introduction
1 Scope
2 References
2.1 Normative references
2.2 Informative references
3 Definitions, symbols and abbreviations
3.1 Definitions
3.2 Symbols
3.3 Abbreviations
4 Functional characteristics
4.1 Cordless audio
4.2 Consumer radio microphones
4.3 In-ear monitoring
5 General
5.1 Presentation of equipment for testing purposes
5.2 Mechanical and electrical design
5.3 Interpretation of the measurement results
6 Test conditions, power sources and ambient
conditions
6.1 Normal and extreme test-conditions
6.2 Test power source
6.3 Normal test conditions
6.4 Extreme test conditions
7 General conditions
7.1 Normal test modulation
7.2 Test fixture
7.3 Test site and general arrangements for radiated
measurements
7.4 Modes of operation of the transmitter
7.5 Arrangement for test signals at the input of the
transmitter
8 Methods of measurement and limits for transmitter
parameters
8.1 Basic requirements for Band II LPD
8.2 Methods of measurement and limits for transmitter
parameters of Band II LPD
8.3 Frequency error
8.4 Carrier power
8.5 Channel bandwidth
8.6 Spurious emissions and cabinet radiation
8.7 Cordless audio transmitter shutoff
9 Receiver
9.1 Spurious emissions and cabinet radiation
10 Measurement uncertainty
10.1 Compliance assessment when measurement uncertainty
is equal to or less than maximum acceptable uncertainty
10.2 Compliance assessment when measurement uncertainty
is greater than maximum acceptable uncertainty
10.3 Maximum allowable measurement uncertainties for cordless
audio and radio microphones
10.4 Maximum allowable measurement uncertainties for
Band II LPD
Annex A (normative): Radiated measurement
A.1 Test sites and general arrangements for
measurements involving the use of radiated
fields
A.2 Guidance on the use of radiation test sites
A.3 Coupling of signals
A.4 Standard test position
A.5 Test fixture
Annex B (normative): Measurement of Necessary
Bandwidth (BN)
Annex C (informative): Receiver parameters
C.1 Blocking or desensitization
C.2 Frequency mask for the receiver part
Annex D (informative): Derivation of radiated spurious
emissions limit for Band II LPD
Annex E (informative): Justifications for field strength
measurement
Annex F (informative): Typical test layout
F.1 Use of vehicle power leads
Annex G (informative): Bibliography
History
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.