EN 50109-2-4:1995

Withdrawn

Hand crimping tools - Tools for the crimp termination of electric cables and wires for low frequency and radio frequency applications - Part 2-4: Particular requirements for centre contacts of RF connectors, series SMZ

Withdrawn date

12-15-1995

Published date

06-22-1995

Publisher

European Committee for Standards - Electrical

Foreword
Introduction
1 Scope
2 Normative references
3 Definitions
4 Requirements
5 Tests and acceptance requirements
6 Calibration procedure
7 Marking, labelling and packaging
8 Type Approval Authority
Annexes
A Crimping tool outline dimensions and constructional
details (normative)
B User control gauges (normative)
C Test piece, locator jig and run-out measurement
details (normaitve)

Part 2-4 of this European Standard specifies detail requirements, limiting dimensions and operating forces for hand crimping tools incorporating a system of multiple indentors of the 8-indent type, commonly known as `Octodent'. It includes test requirements for the tool crimping action, under load, using a test-piece

Committee	CLC/TC 46X
DocumentType	Standard
PublisherName	European Committee for Standards - Electrical
Status	Withdrawn

Standards	Relationship
PN EN 50109-2-4 : 2002	Identical
BS EN 50109-2-4:1996	Identical
UNE-EN 50109-2-4:1993	Identical
DIN EN 50109-2-4:1995-11	Identical
SN EN 50109-2-4 : 1995	Identical
NEN EN 50109-2-4 : 1995	Identical
NBN EN 50109 2-4 : 2000	Identical
NF EN 50109-2-4 : 2004	Identical
I.S. EN 50109-2-4:1997	Identical
CEI EN 50109-2-4 : 1997	Identical

CECC 22000 : 1993	GENERIC SPECIFICATION: RADIO FREQUENCY COAXIAL CONNECTORS
EURONORM 88 : LATEST	REPLACED
EURONORM 83 : 1970	HEAT-TREATABLE STEELS; QUALITY SPECIFICATIONS
EURONORM 86 : 1970	STEELS FOR FLAME-HARDENING AND INDUCTION-HARDENING - QUALITY SPECIFICATIONS
EURONORM 31 : 1969	SEMI-FINISHED PRODUCTS FOR FREE HAMMER FORGING; DEVIATION TOLERANCES FOR DIMENSION, FORM AND WEIGHT
EURONORM 61 : 1982	HOT-ROLLED HEXAGON STEEL
ISO 468:1982	Surface roughness — Parameters, their values and general rules for specifying requirements
EN 50109-1:1995	Hand crimping tools - Tools for the crimp termination of electric cables and wires for low frequency and radio frequency applications - Part 1: General requirements and tests
ISO 286-1:2010	Geometrical product specifications (GPS) ISO code system for tolerances on linear sizes Part 1: Basis of tolerances, deviations and fits
ISO 286-2:2010	Geometrical product specifications (GPS) ISO code system for tolerances on linear sizes Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts
EURONORM 84 : 1970	CASE HARDENING STEELS; QUALITY SPECIFICATIONS
EURONORM 95 : 1979	HEAT-RESISTANT STEELS; TECHNICAL TERMS OF DELIVERY
ISO 4287-1:1984	Surface roughness — Terminology — Part 1: Surface and its parameters
EURONORM 85 : 1970	NITRIDING STEELS; QUALITY SPECIFICATIONS