I.S. EN 1386:2007
Current
The latest, up-to-date edition.
Hardcopy , PDF
English
01-01-2007
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Pattern types
5 Selection of materials
6 Order information
7 Requirements
7.1 General
7.2 Technical conditions for inspection and delivery
7.3 Surface conditions
7.4 Mechanical properties
7.5 Bend test
7.6 Exfoliation corrosion resistance and intergranular
corrosion (5xxx series alloys)
7.7 Tolerances on dimensions and form
7.8 Straightness of the longitudinal edge
7.9 Flatness
7.10 Squareness
8 Inspection and test procedures
8.1 Inspections and tests to be carried out
8.2 Type and content of inspection documents
9 Quality assurance
10 Marking and/or labelling
11 Arbitration
Annex A (normative) Rules for rounding
Annex B (informative) Explanation of temper designation used
in Table 1 based on definitions of EN 515
Bibliography
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.