I.S. EN 140000:1994
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
FIXED RESISTORS (GENERIC SPECIFICATION)
Hardcopy , PDF
11-12-2001
English
01-01-1994
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Cooperating organizations
National foreword
Foreword
Section one. Scope
1. Scope
Section two. General
2. General
2.1 Related documents
2.2 Units, symbols and terminology
2.3 Preferred values
2.4 Marking
2.5 ESD sensitivity
Section three. Quality assessment procedures
3. Quality assessment procedures
3.1 General
3.2 Primary stage of manufacture
3.3 Subcontracting
3.4 Structurally similar components
3.5 Qualification approval procedures
3.6 Capability approval procedures
3.7 Rework and repair work
3.8 Release for delivery
3.9 Certified test records
3.10 Delayed delivery
3.11 Alternative test methods
3.12 Assessed process average procedures
3.13 Manufacture outside the geographical limits of CECC
supervising inspectorates
Section four. Test and measurement procedures
4. Test and measurement procedures
4.1 General
4.2 Standard atmospheric conditions
4.3 Drying
4.4 Visual examination and check of dimensions
4.5 Resistance
4.6 Insulation resistance
4.7 Voltage proof
4.8 Variation of resistance with temperature
4.9 Reactance
4.10 Non-linear properties
4.11 Voltage coefficient
4.12 Noise
4.13 Overload
4.14 Temperature rise
4.15 Robustness of the resistor body
4.16 Robustness of terminations
4.17 Solderability
4.18 Resistance to soldering heat
4.19 Rapid change of temperature
4.20 Bump
4.21 Shock
4.22 Vibration
4.23 Climatic sequence
4.24 Damp heat, steady state
4.25 Endurance
4.26 Accidental overload test (for lower power
non-wirewound resistors only)
4.27 Single-pulse high-voltage overload test
4.28 Periodic pulse high-voltage overload test
4.29 Component solvent resistance
4.30 Solvent resistance of marking
4.31 Shear test and substrate bending test (for surface
mounting resistors only)
4.32 Corrosion
4.33 Flammability
4.34 Seal test (Hermetically sealed resistors only)
Annexes
A. Example of a certified test record (RCE)
B. Internal visual examination of fixed resistors
C. External visual examination of fixed resistors
with enhanced assessment of quality
D. Radiographic inspection of fixed resistors
E. Blank detail specifications
National annex NA (informative) Committees responsible
National annex NB (informative) Cross-references
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.