I.S. EN 16516:2017

Superseded View Superseded By

Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

Preview

CONSTRUCTION PRODUCTS: ASSESSMENT OF RELEASE OF DANGEROUS SUBSTANCES - DETERMINATION OF EMISSIONS INTO INDOOR AIR

Publisher: National Standards Authority of Ireland

Published: 01-01-2017

Available Formats: PDF - English, Hardcopy - English
More Info on product formats

For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

Table of Contents - (Show below) - (Hide below)

National Foreword
European foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviations
4 Intended conditions of use, emission
   scenarios and European reference room
5 Product sampling and transport to the
   laboratory
6 Handling of product samples in the
   laboratory
7 Test chamber conditions
8 Determination of vapour-phase organic
   compounds in test chamber air
9 Calculation of specific emission rates and
   expression of results at the reference room
10 Reporting for the horizontal reference method
11 Indirect methods
Annex A (informative) - Repeatability and reproducibility
Annex B (informative) - Examples of indirect methods
        (also called simplified, screening, secondary, derived
        or alternative methods)
Annex C (informative) - Information on very volatile organic
        compound (VVOC) testing
Annex D (informative) - Example of a form for the sampling
        report
Annex E (informative) - Example form for a chain of custody
        report
Annex F (informative) - Benzene artefact generation on Tenax
Annex G (normative) - List of non-carcinogenic VOCs
Annex H (informative) - List of carcinogenic VOCs
Bibliography

Abstract - (Show below) - (Hide below)

Defines a horizontal reference method for the determination of emissions of regulated dangerous substances from construction products into indoor air.

General Product Information - (Show below) - (Hide below)

Published
Document Type	Standard
Status	Superseded
Publisher	National Standards Authority of Ireland
Pages
ISBN
Supersedes	SR CEN/TS 16516:2013
Superseded By	I.S. EN 16516:2017+A1:2020

International Equivalents – Equivalent Standard(s) & Relationship - (Show below) - (Hide below)

Equivalent Standard(s)	Relationship
EN 16516 : 2017	Identical
EN 16516 : 2017	Identical

Standards Referencing This Book - (Show below) - (Hide below)

ASTM D 7706 : 2017 : REDLINE	Standard Practice for Rapid Screening of VOC Emissions from Products Using Micro-Scale Chambers
CEN/TS 16516 : 2013	CONSTRUCTION PRODUCTS - ASSESSMENT OF RELEASE OF DANGEROUS SUBSTANCES - DETERMINATION OF EMISSIONS INTO INDOOR AIR
ISO 11074 : 2015	SOIL QUALITY - VOCABULARY
EN ISO 12460-5 : 2015	WOOD-BASED PANELS - DETERMINATION OF FORMALDEHYDE RELEASE - PART 5: EXTRACTION METHOD (CALLED THE PERFORATOR METHOD) (ISO 12460-5:2015)
EN ISO 12460-4 : 2016	WOOD-BASED PANELS - DETERMINATION OF FORMALDEHYDE RELEASE - PART 4: DESICCATOR METHOD (ISO 12460-4:2016)
EN ISO 11890-2 : 2013	PAINTS AND VARNISHES - DETERMINATION OF VOLATILE ORGANIC COMPOUND (VOC) CONTENT - PART 2: GAS-CHROMATOGRAPHIC METHOD (ISO 11890-2:2013)
VDA 278 : 2011	THERMAL DESORPTION ANALYSIS OF ORGANIC EMISSIONS FOR THE CHARACTERIZATION OF NON-METALLIC MATERIALS FOR AUTOMOBILES
EN 717-1 : 2004	WOOD-BASED PANELS - DETERMINATION OF FORMALDEHYDE RELEASE - PART 1: FORMALDEHYDE EMISSION BY THE CHAMBER METHOD
ISO 12219-3 : 2012(R2017)	INTERIOR AIR OF ROAD VEHICLES - PART 3: SCREENING METHOD FOR THE DETERMINATION OF THE EMISSIONS OF VOLATILE ORGANIC COMPOUNDS FROM VEHICLE INTERIOR PARTS AND MATERIALS - MICRO-SCALE CHAMBER METHOD
EN ISO 16017-1 : 2000	INDOOR, AMBIENT AND WORKPLACE AIR - SAMPLING AND ANALYSIS OF VOLATILE ORGANIC COMPOUNDS BY SORBENT TUBE/THERMAL DESORPTION/CAPILLARY GAS CHROMATOGRAPHY - PART 1: PUMPED SAMPLING
EN ISO 12460-3 : 2015	WOOD-BASED PANELS - DETERMINATION OF FORMALDEHYDE RELEASE - PART 3: GAS ANALYSIS METHOD (ISO 12460-3:2015)
ISO 13137 : 2013	WORKPLACE ATMOSPHERES - PUMPS FOR PERSONAL SAMPLING OF CHEMICAL AND BIOLOGICAL AGENTS - REQUIREMENTS AND TEST METHODS
EN 717-3 : 1996	WOOD-BASED PANELS - DETERMINATION OF FORMALDEHYDE RELEASE - PART 3: FORMALDEHYDE RELEASE BY THE FLASK METHOD
EN 14662-1 : 2005	AMBIENT AIR QUALITY - STANDARD METHOD FOR MEASUREMENT OF BENZENE CONCENTRATIONS - PART 1: PUMPED SAMPLING FOLLOWED BY THERMAL DESORPTION AND GAS CHROMATOGRAPHY
ISO 16017-1 : 2000(R2016)	INDOOR, AMBIENT AND WORKPLACE AIR - SAMPLING AND ANALYSIS OF VOLATILE ORGANIC COMPOUNDS BY SORBENT TUBE/THERMAL DESORPTION/CAPILLARY GAS CHROMATOGRAPHY - PART 1: PUMPED SAMPLING
ASTM D 5582 : 2014 : REDLINE	Standard Test Method for Determining Formaldehyde Levels from Wood Products Using a Desiccator
EN ISO 13137 : 2013	WORKPLACE ATMOSPHERES - PUMPS FOR PERSONAL SAMPLING OF CHEMICAL AND BIOLOGICAL AGENTS - REQUIREMENTS AND TEST METHODS (ISO 13137:2013)
VDA 277 : 1995	NICHTMETALLISCHE WERKSTOFFE DER KFZ-INNENAUSSTATTUNG - BESTIMMUNG DER EMISSION ORGANISCHER VERBINDUNGEN
EN ISO 16000-11 : 2006	INDOOR AIR - PART 11: DETERMINATION OF THE EMISSION OF VOLATILE ORGANIC COMPOUNDS FROM BUILDING PRODUCTS AND FURNISHING - SAMPLING, STORAGE OF SAMPLES AND PREPARATION OF TEST SPECIMENS
ISO 11890-1 : 2007(R2016)	PAINTS AND VARNISHES - DETERMINATION OF VOLATILE ORGANIC COMPOUND (VOC) CONTENT - PART 1: DIFFERENCE METHOD
CEN/TR 16220 : 2011	CONSTRUCTION PRODUCTS - ASSESSMENT OF RELEASE OF DANGEROUS SUBSTANCES - COMPLEMENT TO SAMPLING
ISO 12460-4 : 2016	WOOD-BASED PANELS - DETERMINATION OF FORMALDEHYDE RELEASE - PART 4: DESICCATOR METHOD
EN ISO 16000-9 : 2006 COR 2007	INDOOR AIR - PART 9: DETERMINATION OF THE EMISSION OF VOLATILE ORGANIC COMPOUNDS FROM BUILDING PRODUCTS AND FURNISHING - EMISSION TEST CHAMBER METHOD
EN 16687 : 2015	CONSTRUCTION PRODUCTS - ASSESSMENT OF RELEASE OF DANGEROUS SUBSTANCES - TERMINOLOGY
ISO 16000-9 : 2006(R2016)	INDOOR AIR - PART 9: DETERMINATION OF THE EMISSION OF VOLATILE ORGANIC COMPOUNDS FROM BUILDING PRODUCTS AND FURNISHING - EMISSION TEST CHAMBER METHOD
ASTM D 6196 : 2016-04	PRACTICE FOR CHOOSING SORBENTS, SAMPLING PARAMETERS AND THERMAL DESORPTION ANALYTICAL CONDITIONS FOR MONITORING VOLATILE ORGANIC CHEMICALS IN AIR
EN ISO 17895 : 2005	PAINTS AND VARNISHES - DETERMINATION OF THE VOLATILE ORGANIC COMPOUND CONTENT OF LOW-VOC EMULSION PAINTS (IN-CAN VOC)
CEN/TR 16496 : 2013	CONSTRUCTION PRODUCTS - ASSESSMENT OF RELEASE OF DANGEROUS SUBSTANCES - USE OF HARMONISED HORIZONTAL ASSESSMENT METHODS
ISO 12460-3 : 2015	WOOD-BASED PANELS - DETERMINATION OF FORMALDEHYDE RELEASE - PART 3: GAS ANALYSIS METHOD
EN ISO 11890-1 : 2007	PAINTS AND VARNISHES - DETERMINATION OF VOLATILE ORGANIC COMPOUND (VOC) CONTENT - PART 1: DIFFERENCE METHOD
ISO 16000-3 : 2011(R2017)	INDOOR AIR - PART 3: DETERMINATION OF FORMALDEHYDE AND OTHER CARBONYL COMPOUNDS IN INDOOR AIR AND TEST CHAMBER AIR - ACTIVE SAMPLING METHOD
ISO 12460-1 : 2007(R2015)	WOOD-BASED PANELS - DETERMINATION OF FORMALDEHYDE RELEASE - PART 1: FORMALDEHYDE EMISSION BY THE 1-CUBIC-METRE CHAMBER METHOD
ISO 12460-5 : 2015	WOOD-BASED PANELS - DETERMINATION OF FORMALDEHYDE RELEASE - PART 5: EXTRACTION METHOD (CALLED THE PERFORATOR METHOD)
ISO 554 : 1976(R2016)	STANDARD ATMOSPHERES FOR CONDITIONING AND/OR TESTING - SPECIFICATIONS
ISO 11890-2 : 2013	PAINTS AND VARNISHES - DETERMINATION OF VOLATILE ORGANIC COMPOUND (VOC) CONTENT - PART 2: GAS-CHROMATOGRAPHIC METHOD
ISO 16000-11 : 2006(R2016)	INDOOR AIR - PART 11: DETERMINATION OF THE EMISSION OF VOLATILE ORGANIC COMPOUNDS FROM BUILDING PRODUCTS AND FURNISHING - SAMPLING, STORAGE OF SAMPLES AND PREPARATION OF TEST SPECIMENS
VDI 2083-17 : 2013	CLEANROOM TECHNOLOGY - COMPATIBILITY OF MATERIALS WITH THE REQUIRED CLEANLINESS
ISO 16000-6 : 2011	INDOOR AIR - PART 6: DETERMINATION OF VOLATILE ORGANIC COMPOUNDS IN INDOOR AND TEST CHAMBER AIR BY ACTIVE SAMPLING ON TENAX TA[R] SORBENT, THERMAL DESORPTION AND GAS CHROMATOGRAPHY USING MS OR MS-FID
ISO 17895 : 2005(R2017)	PAINTS AND VARNISHES - DETERMINATION OF THE VOLATILE ORGANIC COMPOUND CONTENT OF LOW-VOC EMULSION PAINTS (IN-CAN VOC)

Add To Cart

Product Format

Quantity

add to cart

I.S. EN 16516:2017

Table of Contents - (Show below) - (Hide below)

Abstract - (Show below) - (Hide below)

General Product Information - (Show below) - (Hide below)

International Equivalents – Equivalent Standard(s) & Relationship - (Show below) - (Hide below)

Standards Referencing This Book - (Show below) - (Hide below)

Add To Cart

Publisher

Category

Sub Category

Access your standards online with a subscription?