I.S. EN 2002-002:2006
Current
The latest, up-to-date edition.
Hardcopy , PDF
English
01-01-2006
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and symbols
4 Health and safety
5 Principle
6 Testing requirements
7 Test report
Annex A (normative) Types of test piece to be used for sheet
and strip with thickness less than or equal to 8 mm
Annex B (normative) Types of non-machined test piece to be
used in the case of bar, section and wire with a
diameter or thickness less than or equal to 8 mm
Annex C (normative) Types of machined test piece to be used
in the case of bar, section, plate and wire with
diameter or thickness greater than 8 mm and for
forgings and castings
Annex D (normative) Types of test piece to be used in the case
of tubes
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.