I.S. EN 60297-5-103:2001
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
MECHANICAL STRUCTURES FOR ELECTRONIC EQUIPMENT - DIMENSIONS OF MECHANICAL STRUCTURES OF THE 482,6 MM (19 IN) SERIES - SUBRACKS AND ASSOCIATED PLUG-IN UNITS - ELECTROSTATIC DISCHARGE PROTECTION
Hardcopy , PDF
11-03-2004
English
01-01-2001
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Introduction
Clause
1 Scope and object
2 Normative references
3 Definitions
4 Extended feature added to IEC 60297-3 and IEC 60927-4
5 General equipment arrangement
6 Provision for electrostatic discharge protection
6.1 Subrack front and/or rear interface dimensions
for electrostatic discharge protection
6.2 Plug-in unit interface dimensions for
electrostatic discharge protection
Figure 1 - General equipment arrangement - Typical 6U
subrack front and/or rear mounted plug-in units
featured with electrostatic discharge protection
Figure 2 - Subrack guide rail dimensions for the
electrostatic discharge contact position
Figure 3 - Printed board discharge strip dimensions
maintaining ESD contact during connector engagement
Figure 4 - Printed board discharge strip dimensions
breaking ESD contact before connector engagement
Annex ZA (normative) Normative references to international
publications with their corresponding European
publications
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.