I.S. EN 61960-1:2001
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
SECONDARY LITHIUM CELLS AND BATTERIES FOR PORTABLE APPLICATIONS - PART 1: SECONDARY LITHIUM CELLS
Hardcopy , PDF
08-24-2004
English
01-01-2001
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Introduction
1 General
1.1 Scope
1.2 Normative references
1.3 Definitions
1.4 Parameter measurement tolerances
2 Designation and marking
2.1 Cell designation
2.2 Marking
3 Standard types
4 Electrical tests
4.1 Charging procedure for test purposes
4.2 Discharge performance
4.3 Charge (capacity) retention and recovery
4.4 Charge (capacity) recovery after storage
4.5 Endurance in cycles
5 Safety evaluation
5.1 Intended use simulation tests
5.2 Reasonably foreseeable misuse simulation
tests
6 Test protocol and conditions for type approval
6.1 Test protocol
6.2 Conditions for type approval
7 Transportation tests (non-use)
7.1 Transportation tests
7.2 Test protocol
Annex A (informative) Other transportation
requirements
Annex ZA(normative) Normative references to
international publications with their
corresponding European publications
Bibliography
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.