I.S. EN ISO 1463:2004
Withdrawn
A Withdrawn Standard is one, which is removed from sale, and its unique number can no longer be used. The Standard can be withdrawn and not replaced, or it can be withdrawn and replaced by a Standard with a different number.
A Withdrawn Standard is one, which is removed from sale, and its unique number can no longer be used. The Standard can be withdrawn and not replaced, or it can be withdrawn and replaced by a Standard with a different number.
METALLIC AND OXIDE COATINGS - MEASUREMENT OF COATING THICKNESS - MICROSCOPICAL METHOD
Hardcopy , PDF
11-30-2021
English
01-01-2004
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Foreword
1 Scope
2 Normative references
3 Term and definitions
4 Principle
5 Factors relating to measurement uncertainty
5.1 Surface roughness
5.2 Taper of cross-section
5.3 Deformation of
5.4 Rounding of edge of coating
5.5 Overplating
5.6 Etching
5.7 Smearing
5.8 Magnification
5.9 Calibration of stage micrometer
5.10 Calibration of micrometer eyepiece
5.11 Alignment
5.12 Uniformity of magnification
5.13 Lens quality
5.14 Orientation of eyepiece
5.15 Tube length
6 Preparation of cross-sections
7 Measurement
8 Measurement
9 Test report
Annex A (informative) Guidance on the preparation
and measurement of cross-sections
Annex B (informative) Taper of cross-section and
measurement of tooth-constructed coatings
Annex C (informative) Some typical etchants for
use at room temperature
Bibliography
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.