I.S. EN ISO 18595:2007
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Hardcopy , PDF
03-03-2021
English
01-01-2007
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols
5 Material
5.1 Form
5.2 Types of aluminium alloys
6 Surface conditions
7 Edge distance, edge conditions, form of component
and weld spacing
8 Electrodes
8.1 Materials
8.2 Dimensions
8.3 Cooling electrodes
9 Weld assessment
9.1 General
9.2 Weldability test procedure
9.3 Procedure qualification tests
9.4 Production tests
9.5 Frequency of testing
10 Weld quality requirements
10.1 Weld diameter
10.2 Weld dimensions
10.3 Weld fracture mode
10.4 Weld strength
10.5 Weld appearance - Surface condition
11 Multi-weld arrays
Annex A (informative) Recommendations for spot welding
equipment
Annex B (informative) Typical spot welding conditions
Annex C (informative) Non-exhaustive list of aluminium alloys
covered by this International Standard
Annex D (informative) Typical information to appear on a welding
procedure sheet for spot welding
Bibliography
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.