I.S. EN ISO 2566-1:1999
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
STEEL - CONVERSION OF ELONGATION VALUES - PART 1 - CARBON AND LOW ALLOY STEELS
Hardcopy , PDF
01-27-2022
English
01-01-1999
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Foreword
0 Introduction
1 Scope and field of application
2 Symbols
3 Definitions
4 Basic formula
5 Conversion from one proportional gauge length to another
proportional gauge length
6 Conversion from one non-proportional gauge length to
another non-proportional gauge length for test pieces of
equal cross-sectional area
7 Conversion from a proportional gauge length to a
non-proportional gauge length
8 Conversion from a non-proportional gauge length to another
non-proportional gauge length for test pieces of different
cross-sectional areas
9 Use of figures 1 to 5
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.