I.S. EN ISO 2818:1997
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
PLASTICS - PREPARATION OF TEST SPECIMENS BY MACHINING
Hardcopy , PDF
02-08-2019
English
01-01-1997
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Committees responsible
National foreword
Introduction
1 Method
2 Normative references
3 Definitions
4 Test specimens
5 Machinery and tools
6 Procedure
7 Test reports
Annex
A (informative) Bibliography
Table
1 Recommended machining conditions for four types of test
specimen and for notches
Figures
1 Geometry of the active part of cutting tools
2 Shape of milling chips
3 Chip thickness ds in the range between 0.003 mm and 0.007 mm
versus rotational speed n and feed speed vf of a
milling machine (R = 40 mm)
4 Example of a circular cutter (half-section of a diamond-
edged cutter)
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.