I.S. EN ISO 62:2008
Current
The latest, up-to-date edition.
Hardcopy , PDF
English
01-01-2008
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Foreword
Introduction
1 Scope
2 Normative references
3 Principle
4 Apparatus
5 Test specimens
5.1 General
5.2 Square-shaped test specimens for homogeneous
plastics
5.3 Test specimens of reinforced plastics affected by
anisotropic diffusion effects
5.4 Tubular test specimens
5.5 Rod-shaped test specimens
5.6 Specimens cut from finished products, extrusion
compounds, sheets or laminates
6 Test conditions and procedures
6.1 General
6.2 General conditions
6.3 Method 1: Determination of amount of water absorbed
after immersion in water at 23 degrees C
6.4 Method 2: Determination of amount of water absorbed
after immersion in boiling water
6.5 Method 3: Determination of water-soluble matter lost
during immersion
6.6 Method 4: Determination of amount of water absorbed after
exposure to 50% relative humidity
7 Expression of results
7.1 Percentage by mass of water absorbed
7.2 Determination of the water content at saturation and the
water diffusion coefficient using Fick's laws
8 Precision
9 Test report
Annex A (informative) - Correlation between water absorption by
test specimens and Fick's diffusion laws
Annex B (informative) - Precision statement
Bibliography
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.