ICC IRC Code and Commentary Volume 1 : 2015
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
IRC® Code and Commentary, Volume 1
Hardcopy , PDF
08-05-2020
English
01-01-2015
Part I - Administrative
CHAPTER 1 - SCOPE AND ADMINISTRATION
Part II - Definitions
CHAPTER 2 - DEFINITIONS
Part III - Building Planning and Construction
CHAPTER 3 - BUILDING PLANNING
CHAPTER 4 - FOUNDATIONS
CHAPTER 5 - FLOORS
CHAPTER 6 - WALL CONSTRUCTION
CHAPTER 7 - WALL COVERING
CHAPTER 8 - ROOF-CEILING CONSTRUCTION
CHAPTER 9 - ROOF ASSEMBLIES
CHAPTER 10 - CHIMNEYS AND FIREPLACES
Part IV - Energy Conservation
CHAPTER 11 - ENERGY EFFICIENCY
INDEX
The provisions of the International Residential Code for One- and Two-family Dwellings shall apply to the construction, alteration, movement, enlargement, replacement, repair, equipment, use and occupancy, location, removal and demolition of detached one- and two-family dwellings and townhouses not more than three stories above grade plane in height with a separate means of egress and their accessory structures not more than three stories above grade plane in height.
| DevelopmentNote |
COMBO (VOL. 1 + VOL. 2) also available. (09/2015)
|
| DocumentType |
Standard
|
| ISBN |
978-1-60983-284-1
|
| Pages |
881
|
| PublisherName |
International Code Council (ICC)
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| ASTM E 970 : 2017 : REDLINE | Standard Test Method for Critical Radiant Flux of Exposed Attic Floor Insulation Using a Radiant Heat Energy Source |
| ACI 530 : 1995 | BUILDING CODE REQUIREMENTS FOR MASONRY STRUCTURES AND SPECIFICATIONS FOR MASONRY STRUCTURES AND RELATED COMMENTARIES |
| ASTM E 96/E96M : 2016 : REDLINE | Standard Test Methods for Water Vapor Transmission of Materials |
| WDMA IS 11 : 2016 | ANALYTICAL METHOD FOR DESIGN PRESSURE (DP) RATINGS OF FENESTRATION PRODUCTS |
| AITC A190.1 : 2007 | AMERICAN NATIONAL STANDARD, STRUCTURAL GLUED LAMINATED TIMBER |
| ASTM A 615/A615M : 2016-03 | SPECIFICATION FOR DEFORMED AND PLAIN CARBON-STEEL BARS FOR CONCRETE REINFORCEMENT |
| ASTM C 946 : 2010-02 | PRACTICE FOR CONSTRUCTION OF DRY-STACKED, SURFACE-BONDED WALLS |
| ANSI Z97.1 : 2015 | SAFETY GLAZING MATERIALS USED IN BUILDINGS - SAFETY PERFORMANCE SPECIFICATIONS AND METHODS OF TEST |
| ASTM C 1157/C1157M : 2017 : REDLINE | Standard Performance Specification for Hydraulic Cement |
| NFPA 259 : 2013 | STANDARD TEST METHOD FOR POTENTIAL HEAT OF BUILDING MATERIALS |
| ICC 500 : 2008 | STANDARD FOR THE DESIGN AND CONSTRUCTION OF STORM SHELTERS |
| ASTM C 62 : 2017 : REDLINE | Standard Specification for Building Brick (Solid Masonry Units Made From Clay or Shale) |
| CFR 44 : OCT 2017 | EMERGENCY MANAGEMENT AND ASSISTANCE |
| ASTM C 744 : 2016 : REDLINE | Standard Specification for Prefaced Concrete and Calcium Silicate Masonry Units |
| ACI 318 : 2014 | BUILDING CODE REQUIREMENTS FOR STRUCTURAL CONCRETE AND COMMENTARY |
| ASTM E 1996 : 2017 : REDLINE | Standard Specification for Performance of Exterior Windows, Curtain Walls, Doors, and Impact Protective Systems Impacted by Windborne Debris in Hurricanes |
| ICC/ASHRAE 700:2015 | NATIONAL GREEN BUILDING STANDARD |
| ASTM C 212 : 2017 : REDLINE | Standard Specification for Structural Clay Facing Tile |
| ASTM A 706/A706M : 2016 : REDLINE | Standard Specification for Deformed and Plain Low-Alloy Steel Bars for Concrete Reinforcement |
| ASTM C 1240 : 2015 : REDLINE | Standard Specification for Silica Fume Used in Cementitious Mixtures |
| ASTM C 844 : 2015 : REDLINE | Standard Specification for Application of Gypsum Base to Receive<brk/> Gypsum Veneer Plaster |
| ASTM C 645 : 2014-11 | SPECIFICATION FOR NONSTRUCTURAL STEEL FRAMING MEMBERS |
| CFR 16(PTS1000-END) : 0 | COMMERCIAL PRACTICES - FEDERAL TRADE COMMISSION - CONSUMER PRODUCT SAFETY COMMISSION |
| NFPA 13R : 2016 | INSTALLATION OF SPRINKLER SYSTEMS IN LOW-RISE RESIDENTIAL OCCUPANCIES |
| ASTM D 7254 : 2017 : REDLINE | Standard Specification for Polypropylene (PP) Siding |
| ASTM E 2634 : 2017-06 | SPECIFICATION FOR FLAT WALL INSULATING CONCRETE FORM (ICF) SYSTEMS |
| ASTM C 843 : 2017 : REDLINE | Standard Specification for Application of Gypsum Veneer Plaster |
| ASTM D 4897/D4897M : 2016 : REDLINE | Standard Specification for Asphalt-Coated Glass-Fiber Venting Base Sheet Used in Roofing |
| ASTM E 108 : 2017 : REDLINE | Standard Test Methods for Fire Tests of Roof Coverings |
| NFPA 275 : 2017 | STANDARD METHOD OF FIRE TESTS FOR THE EVALUATION OF THERMAL BARRIERS |
| UL 1040:1ED 1996-08 | Fire Test of Insulated Wall Construction |
| ASTM D 5665 : 1999 : REV A : R2006 | Standard Specification for Thermoplastic Fabrics Used in Cold-Applied Roofing and Waterproofing |
| UL 2075:2ED 2013-03 | Gas and Vapor Detectors and Sensors |
| ASME A17.1-2016/CSA B44-16 | Safety code for elevators and escalators (Bi-national standard, with ASME A17.1) |
| ICC A117.1 : 2009 | ACCESSIBLE AND USABLE BUILDINGS AND FACILITIES |
| ASTM D 4829 : 2011 : REDLINE | Standard Test Method for Expansion Index of Soils |
| ICC 600 : 2008 | STANDARD FOR RESIDENTIAL CONSTRUCTION IN HIGH-WIND REGIONS |
| ASTM E 331 : 2000 | Standard Test Method for Water Penetration of Exterior Windows, Skylights, Doors, and Curtain Walls by Uniform Static Air Pressure Difference |
| ASCE 24 05 : 2006 | FLOOD RESISTANT DESIGN AND CONSTRUCTION |
| ASTM D 7032 : 2017 : REDLINE | Standard Specification for Establishing Performance Ratings for Wood-Plastic Composite and Plastic Lumber Deck Boards, Stair Treads, Guards, and Handrails |
| UL 790 : 8 | STANDARD TEST METHODS FOR FIRE TESTS OF ROOF COVERINGS |
| ASTM C 55 : 2017 : REDLINE | Standard Specification for Concrete Building Brick |
| ACI 332 : 2014 | RESIDENTIAL CODE REQUIREMENTS FOR STRUCTURAL CONCRETE AND COMMENTARY |
| ASTM C 34 : 2017 : REDLINE | Standard Specification for Structural Clay Loadbearing Wall Tile |
| ICC 400 : 2007 | STANDARD ON THE DESIGN AND CONSTRUCTION OF LOG STRUCTURES |
| ICC IBC INTERNATIONAL BUILDING CODE : 2015 | INTERNATIONAL BUILDING CODE |
| ASCE 7 10 : 2010 | MINIMUM DESIGN LOADS FOR BUILDINGS AND OTHER STRUCTURES |
| ASTM D 4756 : 2015 : REDLINE | Standard Practice for Installation of Rigid Poly(Vinyl Chloride) (PVC) Siding and Soffit |
| ASTM C 476 : 2016-07 | SPECIFICATION FOR GROUT FOR MASONRY |
| UL 325:7ED 2017-05 | Door, Drapery, Gate, Louver, and Window Operators and Systems |
| ASTM D 226/D226M : 2017 : REDLINE | Standard Specification for Asphalt-Saturated Organic Felt Used in Roofing and Waterproofing |
| NFPA 70 : 2017 | NATIONAL ELECTRICAL CODE |
| ASTM A 996/A996M : 2016 : REDLINE | Standard Specification for Rail-Steel and Axle-Steel Deformed Bars for Concrete Reinforcement |
| ASTM D 7793 : 2017 : REDLINE | Standard Specification for Insulated Vinyl Siding |
| NFPA 72 : 2016 | NATIONAL FIRE ALARM AND SIGNALING CODE |
| NFPA 13 : 2016 | INSTALLATION OF SPRINKLER SYSTEMS |
| ASTM G 155 : 2013 : REDLINE | Standard Practice for Operating Xenon Arc Light Apparatus for Exposure of Non-Metallic Materials |
| ASTM D 3679 : 2017 : REDLINE | Standard Specification for Rigid Poly(Vinyl Chloride) (PVC) Siding |
| NFPA 286 : 2015 | STANDARD METHODS OF FIRE TESTS FOR EVALUATING CONTRIBUTION OF WALL AND CEILING INTERIOR FINISH TO ROOM FIRE GROWTH |
| ASTM C 73 : 2017 : REDLINE | Standard Specification for Calcium Silicate Brick (Sand-Lime Brick) |
| ASTM D 2565 : 2016 : REDLINE | Standard Practice for Xenon-Arc Exposure of Plastics Intended for Outdoor Applications |
| NFPA 720 : 2015 | INSTALLATION OF CARBON MONOXIDE (CO) DETECTION AND WARNING EQUIPMENT |
| ICC IPC INTERNATIONAL PLUMBING CODE : 2015 | INTERNATIONAL PLUMBING CODE (INCLUDES IPSDC) |
| ASTM D 3161/D3161M : 2016-01 | TEST METHOD FOR WIND-RESISTANCE OF STEEP SLOPE ROOFING PRODUCTS (FAN-INDUCED METHOD) |
| UL 263:14ED 2011-06 | Fire Tests of Building Construction and Materials |
| ASTM C 615/C615M : 2011-01 | SPECIFICATION FOR GRANITE DIMENSION STONE |
| FM 4880 : 2017 | EVALUATING THE FIRE PERFORMANCE OF INSULATED BUILDING PANEL ASSEMBLIES AND INTERIOR FINISH MATERIALS |
| NFPA 13D : 2016 | INSTALLATION OF SPRINKLER SYSTEMS IN ONE- AND TWO-FAMILY DWELLINGS AND MANUFACTURED HOMES |
| ANSI Z21.83 : 0 | FUEL CELL POWER PLANTS |
| ICC IFC INTERNATIONAL FIRE CODE : 2015 | INTERNATIONAL FIRE CODE |
| ASCE 32 01 : 2001 | DESIGN AND CONSTRUCTION OF FROST-PROTECTED SHALLOW FOUNDATIONS |
| ASTM C 954 : 2015-06 | SPECIFICATION FOR STEEL DRILL SCREWS FOR THE APPLICATION OF GYPSUM PANEL PRODUCTS OR METAL PLASTER BASES TO STEEL STUDS FROM 0.033 IN. (0.84 MM) TO 0.112 IN. (2.84 MM) IN THICKNESS |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.