Skip to content
Please enter a keyword to search

  • IEEE C37.63 : 2013

    Current The latest, up-to-date edition.
    Add to Watchlist
    This Standard has been added successfully to your Watchlist.
    Please visit My Watchlist to see all standards that you are watching.
    Please log in or to add this standard to your Watchlist.
    We could not add this standard to your Watchlist.
    Please retry or contact support for assistance.
    We could not add this standard to your Watchlist.
    Please retry or contact support for assistance.
    You have already added this standard to your Watchlist.
    Visit My Watchlist to view the full list.

    REQUIREMENTS FOR OVERHEAD, PAD-MOUNTED, DRY-VAULT, AND SUBMERSIBLE AUTOMATIC LINE SECTIONALIZERS FOR ALTERNATING CURRENT SYSTEMS UP TO 38 KV

    Available format(s):  Hardcopy, PDF

    Language(s):  English

    Published date:  04-26-2013

    Publisher:  Institute of Electrical & Electronics Engineers

    Add to Watchlist

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    1. Overview
    2. Normative references
    3. Definitions
    4. Normal (usual) and special (unusual) service conditions
    5. Ratings
    6. Design and construction
    7. Design (type) tests
    8. Production tests (routine tests)
    Annex A (informative) - X/R ratios
    Annex B (normative) - Ratings for series coil sectionalizers
    Annex C (informative) - Bibliography

    Abstract - (Show below) - (Hide below)

    This standard applies to all overhead, pad-mounted, dry-vault, and submersible single-pole or multipole alternating-current automatic line sectionalizers for rated maximum voltages above 1 kV and up to 38 kV.

    General Product Information - (Show below) - (Hide below)

    Development Note Supersedes IEEE DRAFT C37.63. (11/1999)
    Document Type Standard
    Publisher Institute of Electrical & Electronics Engineers
    Status Current
    Supersedes

    Standards Referenced By This Book - (Show below) - (Hide below)

    IEEE 386-2016 SEPARABLE INSULATED CONNECTOR SYSTEMS FOR POWER DISTRIBUTION SYSTEMS RATED 2.5 KV THROUGH 35 KV
    TM 5-811-1 : V19950228 ARMY TECHNICAL MANUAL - ELECTRICAL POWER SUPPLY AND DISTRIBUTION
    ESI 41-27 : ISSUE 1 AMD 2 OUTDOOR DISTRIBUTION SWITCHGEAR FOR SERVICE UP TO 36kV (OVERHEAD CONDUCTOR CONNECTED)
    IEEE C57.12.32-2002 SUBMERSIBLE EQUIPMENT - ENCLOSURE INTEGRITY
    IEEE C37.104-2012 GUIDE FOR AUTOMATIC RECLOSING OF LINE CIRCUIT BREAKERS FOR AC DISTRIBUTION AND TRANSMISSION LINES
    ENA TS 41-27 : ISSUE 1 AMD 3 OUTDOOR DISTRIBUTION SWITCHGEAR FOR SERVICE UP TO 36 KV (OVERHEAD CONDUCTOR CONNECTED)

    Standards Referencing This Book - (Show below) - (Hide below)

    IEEE C57.12.32-2002 SUBMERSIBLE EQUIPMENT - ENCLOSURE INTEGRITY
    IEC 60502:1994 Extruded solid dielectric insulated power cables for rated voltages from 1 kV up to 30 kV
    IEEE C37.100.1 : 2007 COMMON REQUIREMENTS FOR HIGH VOLTAGE POWER SWITCHGEAR RATED ABOVE 1000 V
    IEEE/IEC C37.60-2012 REDLINE IEEE/IEC International Standard - High-voltage switchgear and controlgear - Part 111: Automatic circuit reclosers and fault interrupters for alternating current systems up to 38 kV
    IEEE 386-2016 SEPARABLE INSULATED CONNECTOR SYSTEMS FOR POWER DISTRIBUTION SYSTEMS RATED 2.5 KV THROUGH 35 KV
    IEEE 400.1 : 2007 GUIDE FOR FIELD TESTING OF LAMINATED DIELECTRIC, SHIELDED POWER CABLE SYSTEMS RATED 5 KV AND ABOVE WITH HIGH DIRECT CURRENT VOLTAGE
    IEEE C37.42-2009 HIGH-VOLTAGE (>1000 V) FUSES AND ACCESSORIES
    CSA C22.2 No. 31 : 2014 SWITCHGEAR ASSEMBLIES
    IEEE 400.2 : 2013 GUIDE FOR FIELD TESTING OF SHIELDED POWER CABLE SYSTEMS USING VERY LOW FREQUENCY (VLF) (LESS THAN 1 HZ)
    IEEE 4-2013 HIGH-VOLTAGE TESTING TECHNIQUES
    IEEE 1247 : 2005 INTERRUPTER SWITCHES FOR ALTERNATING CURRENT, RATED ABOVE 1000 V
    IEEE C37.09 : 1999 TEST PROCEDURE FOR AC HIGH-VOLTAGE CIRCUIT BREAKERS RATED ON A SYMMETRICAL CURRENT BASIS
    IEC 62271-1:2017 High-voltage switchgear and controlgear - Part 1: Common specifications for alternating current switchgear and controlgear
    IEEE C57.12.28:2014 PAD-MOUNTED EQUIPMENT - ENCLOSURE INTEGRITY
    IEEE C37.48.1-2002 GUIDE FOR THE APPLICATION, OPERATION, AND COORDINATION OF HIGH-VOLTAGE (>1000 V) CURRENT-LIMITING FUSES
    View more information

    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective