Production equipment for microsystems Interface between end effector and handling system

Available format(s)

Hardcopy , PDF , PDF 3 Users , PDF 5 Users , PDF 9 Users

Language(s)

English, French

Published date

02-17-2011

Publisher

International Organization for Standardization

ISO 29262:2011 specifies provisions for the interface between end effector and handling systems in production equipment for microsystems. It specifies principal deviations, tolerances and designations for manually and automatically changeable end effectors. The aim is to specify the end effector interface in three levels with an increasing degree of specification.

DevelopmentNote	Supersedes ISO/DIS 29262. (02/2011)
DocumentType	Standard
Pages	17
ProductNote	THIS STANDARD ALSO REFERS TO IEC/TS 60479-3
PublisherName	International Organization for Standardization
Status	Current

Standards	Relationship
DIN ISO 29262:2013-03	Identical
BS ISO 29262:2011	Identical
DIN ISO 29262 E : 2013	Identical
NF ISO 29262 : 2013	Identical

DIN 32564-1:2004-05	Production equipment for micro-systems - Terms and definitions - Part 1: General terms of micro-system technology
DIN 509:2006-12	Technical drawings - Undercuts - Types and dimensions
EN 50295:1999	Low-voltage switchgear and controlgear - Controller and device interface systems - Actuator Sensor interface (AS-i)
ISO/IEC 24702:2006	Information technology Generic cabling Industrial premises
ISO 1101:2017	Geometrical product specifications (GPS) — Geometrical tolerancing — Tolerances of form, orientation, location and run-out
IEEE 802.3-2012	IEEE Standard for Ethernet
TIA/EIA 568-2 : C2009 AMD 1 2016	COMMERCIAL BUILDING TELECOMMUNICATIONS CABLING STANDARD - PART 2: BALANCED TWISTED-PAIR TELECOMMUNICATIONS CABLING AND COMPONENTS STANDARDS
ISO/IEC 11801:2002	Information technology Generic cabling for customer premises
ISO 9409-2:2002	Manipulating industrial robots Mechanical interfaces Part 2: Shafts
IEC 62026-2:2008	Low-voltage switchgear and controlgear - Controller-device interfaces (CDIs) - Part 2: Actuator sensor interface (AS-i)
ISO 3650:1998	Geometrical Product Specifications (GPS) Length standards Gauge blocks
ISO 286-1:2010	Geometrical product specifications (GPS) ISO code system for tolerances on linear sizes Part 1: Basis of tolerances, deviations and fits
ISO 9409-1:2004	Manipulating industrial robots — Mechanical interfaces — Part 1: Plates
ISO 286-2:2010	Geometrical product specifications (GPS) ISO code system for tolerances on linear sizes Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts
ISO/IEC 24740:2008	Information technology Responsive Link (RL)
ISO 9787:2013	Robots and robotic devices Coordinate systems and motion nomenclatures
IEC 61131-2:2017	Industrial-process measurement and control - Programmable controllers - Part 2: Equipment requirements and tests
DIN 7154-1:1966-08	ISO-FITS FOR THE HOLE BASIS SYSTEM; TOLERANCE ZONES, DEVIATIONS
IEC 61140:2016	Protection against electric shock - Common aspects for installation and equipment
ISO 8734:1997	Parallel pins, of hardened steel and martensitic stainless steel (Dowel pins)
DIN 7154-2:1966-08	ISO-FITS FOR THE HOLE BASIC SYSTEM; TOLERANCES OF FIT (CLEARANCES AND INTERFERENCES)
IEC TR 60479-3:1998	Effects of current on human beings and livestock - Part 3: Effects of currents passing through the body of livestock
ISO 18265:2013	Metallic materials — Conversion of hardness values