GRAPHIC SYMBOLS FOR DRAWINGS - PART 1: FACILITIES STANDARD FOR

Published date

01-01-1992

Publisher

National Aeronautics and Space Administration

1 SCOPE
2 APPLICABLE DOCUMENTS
  2.1 Governmental
      2.1.1 Standards
      2.1.2 Drawings
      2.1.3 Publications
  2.2 Non-Governmental
3 REQUIREMENTS
  3.1 General
  3.2 Civil
  3.3 Architectural
  3.4 Structural
  3.5 Mechanical
      3.5.1 Plumbing
      3.5.2 Heating Ventilating and Air Conditioning (HVAC)
  3.6 Electrical
      3.6.1 Electrical Power Receptacles
      3.6.2 Electrical Plan Views
      3.6.3 Electrical Wiring or Control Diagrams
      3.6.4 Electrical Single-Line Diagrams
      3.6.5 Fire Alarms and Emergency Communication
      3.6.6 Electronic Security and Intrusion Detection Systems
      3.6.7 Special Identification
  3.7 Letter Symbols
  3.8 Mathematical Signs and Symbols
  3.9 Surface Texture
4 QUALITY ASSURANCE PROVISIONS
5 PREPARATION FOR DELIVERY
6 NOTES
  6.1 Intended Use
  6.2 Definitions
APPENDIX A - PLUMBING GRAPHIC SYMBOLS FOR FACILITIES DRAWINGS
APPENDIX B - ELECTRICAL GRAPHIC SYMBOLS FOR FACILITIES DRAWINGS
APPENDIX C - FIRE ALARM AND EMERGENCY COMMUNICATION SYSTEMS GRAPHIC
             SYMBOLS FOR FACILITIES DRAWINGS
APPENDIX D - ELECTRONIC SECURITY AND INTRUSION DETECTION SYSTEMS
             GRAPHIC SYMBOLS FOR FACILITIES DRAWINGS

Applicable to those symbols used on civil, architectural, structural, mechanical, and electrical drawings used to construct or modify facilities and other drawings required for operation, maintenance, or other use of the facilities.

DocumentType	Standard
PublisherName	National Aeronautics and Space Administration
Status	Current

NASA KSC GP 435 VOL 2 : 1993	ENGINEERING DRAWING PRACTICES - VOLUME 2: FACILITIES
NASA KSC GP 435 VOL 1 : 2014	ENGINEERING DRAWING PRACTICES - VOLUME 1: AEROSPACE AND GROUND SUPPORT EQUIPMENT
NASA KSC STD E 0004 : 2008	PNEUMATIC AND HYDRAULIC MECHANICAL COMPONENTS, ELECTRICAL DESIGN, STANDARD FOR

NFPA 172 : 1986	STANDARD FIRE PROTECTION SYMBOLS FOR ARCHITECTURAL AND ENGINEERING DRAWINGS
AWS A2.4 : 2012	STANDARD SYMBOLS FOR WELDING, BRAZING, AND NONDESTRUCTIVE EXAMINATION
NASA KSC STD E 0011 : 2009	ELECTRICAL POWER RECEPTACLES AND PLUGS, STANDARD FOR
IEEE 260-1978	IEEE Standard Letter Symbols for Units of Measurement (SI Units, Customary Inch-Pound Units, and Certain Other Units)
IEEE/ANSI Y32.9-1972	American National Standard Graphic Symbols for Electrical Wiring and Layout Diagrams Used in Architecture and Building Construction
ASHRAE HDBK FUNDAMENTALS : 2013	ASHRAE HANDBOOK - FUNDAMENTALS
IEEE 315 : 1975	GRAPHIC SYMBOLS FOR ELECTRICAL AND ELECTRONICS DIAGRAMS (INCLUDING REFERENCE DESIGNATION LETTERS)
AISC M015 : 1ED	LOAD AND RESISTANCE FACTOR DESIGN (LRFD) MANUAL OF STEEL CONSTRUCTION
MIL-STD-14 Revision A:1954	ARCHITECTURAL SYMBOLS