NBN EN 10225 : 2009

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Information to be supplied by the purchaser
5 Dimensions, mass and tolerances
6 Classification and designation
7 Manufacturing process
8 Requirements
9 Inspection and testing
10 Sampling
11 Test methods
12 Marking, bundling and protective coating
13 Options
Annex A (normative) - Location of test samples for
                        tensile and impact tests
Annex B (normative) - Location of tensile test piece
                        when two rolled surfaces cannot
                        be retained
Annex C (normative when option 2 is specified by the
        purchaser) - Details of manufacturing procedures
                        to be supplied by the manufacturer
                        for steels of groups 2 and 3
Annex D (normative when option 16 is specified by the
        purchaser) - Cold forming characteristics for
                        steel plate of groups 2 and 3
Annex E (normative when option 18 is specified by the
        purchaser) - Weldability testing for steels of
                        groups 2 and 3 and mechanical
                        testing of butt welds
Annex F (normative when option 18 is specified by the
        purchaser) - Weldability testing for steels of
                        groups 2 and 3 - Bead-on-plate
Annex G (normative) - Weldability testing for steels of
                        groups 2 and 3 - Controlled thermal
                        severity tests (CTS)
Annex H (informative) - National standards which correspond
                        to EURONORMS referenced
Bibliography