NBN EN 13126-8 : 2006

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Classification
  4.1 General
  4.2 Category of use (1 - first digit)
  4.3 Durability (2 - second digit)
  4.4 Mass (3 - third digit)
  4.5 Fire resistance (4 - fourth digit)
  4.6 Safety in use (5 - fifth digit)
  4.7 Corrosion resistance (6 - sixth digit)
  4.8 Security (7 - seventh digit)
  4.9 Applicable part (8 - eighth digit)
  4.10 Test sizes (9 - ninth digit)
  4.11 Example of classification for Tilt&Turn hardware
5 Requirements
  5.1 General
  5.2 Mechanical stability
      5.2.1 Stability of the scissor stay
      5.2.2 Mechanical strength of hinges
  5.3 Durability
  5.4 Admissible tolerances
      5.4.1 Sash operation tolerance
      5.4.2 Handle operation tolerance
      5.4.3 Locking point variable tolerance
  5.5 Resistance to additional loading
  5.6 Minimum closing device resistance
  5.7 Corrosion resistance
  5.8 Resistance to other additional tests
6 Test equipment
7 Test procedures
  7.1 Samples
  7.2 Stability of hinge
  7.3 Durability test - Tilt&Turn
      7.3.1 General
      7.3.2 Tilt&Turn cycles - Tilt-First cycles
      7.3.3 Turn cycles (into 90 degree turn position)
      7.3.4 Acceptance criteria
      7.3.5 Additional loading test - 1000 N
      7.3.6 Reveal test for hardware without turn-restrictor
      7.3.7 Test for hardware with turn-restrictor
      7.3.8 Rebate-hindrance test
  7.4 Durability test - Turn-Only hardware
  7.5 Minimum closing device resistance test
  7.6 Corrosion resistance
Annex A (informative) Typical test equipment
Annex B (normative) Flow chart of test procedures
Bibliography