• NFPA 501C : 1996

    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    Add to Watchlist
    This Standard has been added successfully to your Watchlist.
    Please visit My Watchlist to see all standards that you are watching.
    Please log in or to add this standard to your Watchlist.
    We could not add this standard to your Watchlist.
    Please retry or contact support for assistance.
    We could not add this standard to your Watchlist.
    Please retry or contact support for assistance.
    You have already added this standard to your Watchlist.
    Visit My Watchlist to view the full list.

    RECREATIONAL VEHICLES

    Available format(s): 

    Superseded date:  02-15-1999

    Language(s): 

    Published date:  01-12-2013

    Publisher:  National Fire Protection Association

    Add to Watchlist

    Sorry this product is not available in your region.

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    Chapter 1 General
    1.1 Introduction
    1.2 Scope
    1.3 Definitions
    1.4 Requirements common to chapters 2 and 3
    1.5 Electrical requirements
    1.6 Use of International System of Units (SI)
    Chapter 2 Fuel systems and equipment
    2.1 Quality of design and installation
    2.2 LP-gas systems
    2.3 Fuel oil supply for heat-producing appliances
    2.4 Fuel gas piping systems
    2.5 Fuel oil piping system
    2.6 Fuel-burning appliances
    2.7 Circulating air systems for heating (other than
          automotive-type)
    2.8 Air conditioning (other than automotive-type)
    2.9 Consumer information
    2.10 Gasoline or diesel fuel systems for engine
          generator sets for travel trailers and fifth
          wheels
    2.11 LP-gas engine fuel installations
    Chapter 3 Fire and life safety provisions
    3.1 Interior finish and textile or film materials
    3.2 Recreational vehicle exit facilities
    3.3 Fire detection equipment
    3.4 Other considerations
    Chapter 4 Plumbing systems
    4.1 Introduction to chapter
    4.2 Scope of chapter
    4.3 Definitions applicable to chapter 4
    4.4 Plumbing system, general requirements
    4.5 Plumbing fixtures
    4.6 Water distribution systems
    4.7 Drainage systems
    4.8 Vents and venting
    4.9 Plumbing system tests
    Chapter 5 Referenced publications
    Appendix A
    Appendix B Gas piping sizing
    Index

    Abstract - (Show below) - (Hide below)

    Provides fire safety guidelines for fuel systems, fire detection equipment, exiting facilities, and plumbing systems, including water distribution and drainage systems. This document results from the cooperation of NFPA and RVIA. Note: National Fire Codes addresses firesafety issues only

    General Product Information - (Show below) - (Hide below)

    Development Note Renumbered to NFPA 1192
    Document Type Standard
    Publisher National Fire Protection Association
    Status Superseded
    Superseded By

    Standards Referencing This Book - (Show below) - (Hide below)

    ANSI Z124.4 : 2006 PLASTIC WATER CLOSET BOWLS AND TANKS
    ASTM E 380 : 1993 Standard Practice for Use of the Internation System of Units (SI) (the Modernized Metric System) (Withdrawn 1997)
    ANSI Z97.1 : 2015 SAFETY GLAZING MATERIALS USED IN BUILDINGS - SAFETY PERFORMANCE SPECIFICATIONS AND METHODS OF TEST
    NFPA 58 : 2017 LIQUEFIED PETROLEUM GAS CODE
    UL 94 : 6 TESTS FOR FLAMMABILITY OF PLASTIC MATERIALS FOR PARTS IN DEVICES AND APPLIANCES
    NFPA 255 : 2006 TEST OF SURFACE BURNING CHARACTERISTICS OF BUILDING MATERIALS
    UL 217 : 8 SMOKE ALARMS
    ASME A112.19.2M : 98 SUPP 1 VITREOUS CHINA PLUMBING FIXTURES
    NFPA 10 : 2018 PORTABLE FIRE EXTINGUISHERS
    UL 181 : 2011 FACTORY-MADE AIR DUCTS AND AIR CONNECTORS
    ASTM B 88 : 2016 : REDLINE Standard Specification for Seamless Copper Water Tube
    ASME PV CODE 8 DIV 1 : 2017 BOILER AND PRESSURE VESSEL CODE - RULES FOR CONSTRUCTION OF PRESSURE VESSELS DIVISION 1
    ASTM A 539 : 1999 Standard Specification for Electric-Resistance-Welded Coiled Steel Tubing for Gas and Fuel Oil Lines (Withdrawn 2004)
    NFPA 70 : 2017 NATIONAL ELECTRICAL CODE
    NFPA 97 : 2003 GLOSSARY OF TERMS RELATING TO CHIMNEYS, VENTS, AND HEAT-PRODUCING APPLIANCES
    SAE J 30 : 2012 FUEL AND OIL HOSES
    SAE J 533 : 2017 FLARES FOR TUBING
    ASME B1.20.1 : 2013(R2018) PIPE THREADS, GENERAL PURPOSE (INCH)
    UL 569 : 8 PIGTAILS AND FLEXIBLE HOSE CONNECTORS FOR LP-GAS
    ASME B36.10M : 2015 WELDED AND SEAMLESS WROUGHT STEEL PIPE
    ANSI A119.5 : 2009 PARK MODEL RECREATIONAL VEHICLE STANDARD
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective