NS EN ISO 10724-1 : 1ED 2001

Foreword
Introduction
1 Scope
2 Normative references
3 Definitions
  3.1 Mould temperature
  3.2 Melt temperature
  3.3 Melt pressure
  3.4 Hold pressure
  3.5 Moulding cycle
  3.6 Cycle time
  3.7 Injection time
  3.8 Cure time
  3.9 Hold time
  3.10 Mould-open time
  3.11 Cavity
  3.12 Multi-cavity mould
  3.13 ISO mould
  3.14 Critical cross-sectional area
  3.15 Moulding volume
  3.16 Projected area
  3.17 Locking force
  3.18 Injection velocity
  3.19 Mass of the moulding
  3.20 Shot Capacity
4 Apparatus
  4.1 ISO (multi-cavity) moulds
  4.2 Injection-moulding machine
      4.2.1 Moulding volume
      4.2.2 Control system
      4.2.3 Screw
      4.2.4 Locking force
      4.2.5 Thermometers
5 Procedure
  5.1 Conditioning of material
  5.2 Injection moulding
  5.3 Measurement of the mould temperature
  5.4 Measurement of the melt temperature
  5.5 Post-moulding treatment of test specimens
6 Report on test-specimen preparation
Annex A (informative) Examples of runner configurations
Annex B (informative) Marking the test specimens
Annex C (informative) Example of an injection mould
Annex D (informative) Standardized injection-moulding
                      mould components
Annex ZA (normative) Normative references to international publications
         with their relevant European publications