Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Test equipment
5 Test conditions
   5.1 Heating conditions
   5.2 Pressure conditions
6 Test specimen
   6.1 General
   6.2 Size
   6.3 Number of test specimens
7 Installation of test specimen
   7.1 General
   7.2 Supporting construction
        7.2.1 General
        7.2.2 Standard supporting construction
   7.3 Test construction
   7.4 Splice locations
   7.5 Induced movement
8 Conditioning
9 Application of instrumentation
   9.1 General
   9.2 Thermocouples
        9.2.1 Furnace thermocouples
        9.2.2 Unexposed face thermocouples
        9.2.3 Roving thermocouple
   9.3 Deformation and deflection
   9.4 Integrity measurement
10 Test procedure
   10.1 General
   10.2 Installation of test construction
   10.3 Mechanically induced movement of the test specimen
   10.4 Measurements and observations
11 Performance criteria
   11.1 Insulation
   11.2 Integrity
   11.3 Expression of results
12 Test report
13 Field of direct application of test results
   13.1 Orientation
   13.2 Supporting construction
   13.3 Seal position
   13.4 Mechanically induced movement
Annex A (normative) Standard condition for linear joint seals with
        no mechanically induced movement of the joint faces
        A.1 Standard condition
        A.2 Test procedure
Annex B (normative) Standard condition for linear joint seals with
        mechanically induced movement of the joint faces
        B.1 General
        B.2 Standard condition(s)
            B.2.1 Standard conditions for lateral movement
            B.2.2 Standard condition for shear movement
        B.3 Conditions for other movements
Annex C (informative) Guidance on the use of this European Standard
        C.1 General
        C.2 Application of the test
        C.3 Test conditions
        C.4 Specimen preparation
        C.5 Notes on general performance criteria
        C.6 Notes on validity of test results
        C.7 Notes on Annex B