PREN 2002-02 : 200P3
Withdrawn
A Withdrawn Standard is one, which is removed from sale, and its unique number can no longer be used. The Standard can be withdrawn and not replaced, or it can be withdrawn and replaced by a Standard with a different number.
A Withdrawn Standard is one, which is removed from sale, and its unique number can no longer be used. The Standard can be withdrawn and not replaced, or it can be withdrawn and replaced by a Standard with a different number.
Hardcopy , PDF
12-06-2023
English
0 Introduction
1 Scope
2 Normative references
3 Definitions
4 Health and safety
5 Principle
6 Testing requirements
7 Test report
Annex A (normative) Types of test piece to be used for sheet
and strip with thickness less than 8 mm
Annex B (normative) Types of non-machined test piece to be used
in the case of bar, section and wire with a
diameter or thickness less than or equal to
8 mm
Annex C (normative) Types of machined test piece to be used in
the case of bar, section, plate and wire
with diameter or thickness greater than 8 mm
and for forgings and castings
Annex D (normative) Types of test piece to be used in the case
of tubes
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.