SN EN 61046 : 1994 AMD 1 1996
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
DIRECT CURRENT OR ALTERNATING CURRENT SUPPLIED ELECTRONIC STEP-DOWN CONVERTORS FOR FILAMENT LAMPS - GENERAL AND SAFETY REQUIREMENTS
01-01-2001
01-12-2013
Foreword
Section 1 - General requirements
1. General
1.1 Scope
1.2 Normative references
2. Definitions
3. General requirements
4. General notes on tests
5. Classification
6. Marking
Section 2 - Safety requirements
7. Terminals
8. Provisions for earthing
9. Construction
10. Creepage distances and clearances
11. Protection against accidental contact with live parts
12. Moisture resistance and insulation
13. Electric strength
14. Transformer heating
15 Abnormal conditions
16. Fault conditions
17. Screws, current-carrying parts and connections
18. Resistance to heat and fire
19. Resistance to corrosion
Figure 1
Annexes
A. Test to establish whether a conductive part is a
live part which may cause an electric shock
B. Particular requirements for d.c. or a.c. supplied
electronic step-down convertors for filament lamps
with means of protection against overheating
C. Particular additional requirements for independent
SELV d.c. or a.c. supplied electronic step-down
convertors for filament lamps
Annex ZA (normative) Other international publications
quoted in this standard with the references of
the relevant European publications
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.