SN EN 61347-2-8 : 2001 AMD 1 2006

INTRODUCTION
1 Scope
2 Normative references
3 Definitions
4 General requirements
   4.1 Capacitors and other components
   4.2 Thermally protected ballasts
5 General notes on tests
6 Classification
7 Marking
   7.1 Mandatory markings
   7.2 Information to be provided, if applicable
   7.3 Other information
8 Protection against accidental contact with live
   parts
9 Terminals
10 Provisions for earthing
11 Moisture resistance and insulation
12 Electric strength
13 Thermal endurance test for windings
14 Ballast heating
   14.1 Pre-test, checks and measures
   14.2 Voltage across capacitors
   14.3 Ballast heating test
15 High-voltage impulse testing
16 Fault conditions
17 Construction
18 Creep age distances and clearances
19 Screws, current-carrying parts and connections
20 Resistance to heat, fire and tracking
21 Resistance to corrosion
22 No-load output voltage
Annex A (normative) Test to establish whether a
         conductive part is a live part, which may
         cause an electric shock
Annex B (normative) Particular requirements for
         thermally protected lamp controlgear
Annex C (normative) Particular requirements for
         electronic lamp controlgear with means of
         protection against overheating
Annex D (normative) Requirements for carrying out the
         heating tests of thermally protected lamp
         controlgear
Annex E (normative) Use of constant S other than 4500
         in tw tests
Annex F (normative) Draught-proof enclosure
Annex G (normative) Explanation of the derivation of
         the pulse voltages
Annex H (normative) Tests
Annex I (normative) Method for selection of varistors
Annex J (informative) Explanation of ballast temperatures
Annex K (normative) Additional requirements for built-in
         magnetic ballasts with double or reinforced insulation
Annex ZA (normative) Normative references to
         international publications with their
         corresponding European publications
Bibliography