STANAG 4241 : 2003

Superseded View Superseded By

Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

BULLET IMPACT, MUNITION TEST PROCEDURES

Publisher: NATO

Published:

Available Formats: PDF - English, Hardcopy - English
More Info on product formats

Abstract - (Show below) - (Hide below)

Gives a standard test procedure for assessing the reaction of a munition to an impact from a three-round burst of M2, calibre 0.50 0.50 in, AP projectiles and also provides an alternative, tailorable, test procedure for assessing the reaction, if any, of a munition to the impact of one or more projectiles that are typical of those determined by means of a threat hazard assessment (THA).

General Product Information - (Show below) - (Hide below)

Published
Document Type	Standard
Status	Superseded
Publisher	NATO
Pages
ISBN
Superseded By	STANAG 4241:2018

Standards Referenced By This Book - (Show below) - (Hide below)

STANAG 4517 : 2007	LARGE CALIBRE ORDNANCE/MUNITION COMPATIBILITY DESIGN SAFETY REQUIREMENTS AND SAFETY AND SUITABILITY FOR SERVICE EVALUATION
STANAG 4432 : 0	AIR-LAUNCHED GUIDED MUNITIONS: PRINCIPLES FOR SAFE DESIGN
STANAG 1402 : 2000	GUIDELINES FOR THE NATIONAL TEST AUTHORITY (NTA) ASSESSMENT OF NAVAL AMMUNITION INTERCHANGEABILITY
AAS3P-20 : 2017	SAFETY AND SUITABILITY FOR SERVICE ASSESSMENT TESTING OF LARGE CALIBER AMMUNITION GREATER THAN 40MM
STANAG 4608 : 2006	AMMUNITION BELOW 12.7 MM CALIBRE - DESIGN SAFETY REQUIREMENTS AND SAFETY SUITABILITY FOR SERVICE (S[3]) EVALUATION
STANAG 4493 : 2007	TANK AMMUNITION, SAFETY AND SUITABILITY FOR SERVICE EVALUATION
AAS3P-12 : 2017	SAFETY AND SUITABILITY FOR SERVICE ASSESSMENT TESTING FOR AIRCRAFT LAUNCHED MUNITIONS
STANAG 4519 : 0	GAS GENERATORS, DESIGN SAFETY PRINCIPLES AND SAFETY AND SUITABILITY FOR SERVICE EVALUATION
STANAG 4325 : 2002	AIR-LAUNCHED MUNITIONS SAFETY AND SUITABILITY FOR SERVICE EVALUATION
AOP 31 : 0	DEMOLITION MATERIEL - DESIGN PRINCIPLES
STANAG 4423 : 2003	CANNON AMMUNITION (12.7 TO 40 MM), SAFETY AND SUITABILITY FOR SERVICE EVALUATION
STANAG 4337 : 0	SURFACE LAUNCHED MUNITION APPRAISAL, SAFETY AND ENVIRONMENTAL TESTS
STANAG 4333 : 0	UNDERWATER MUNITIONS, PRINCIPLES FOR SAFE DESIGN
STANAG 4338 : 0	UNDERWATER-LAUNCHED MUNITIONS, SAFETY EVALUATION
DEFSTAN 00-101(PT4)/1(2005) : 2005	DESIGN STANDARDS FOR EXPLOSIVES SAFETY IN MOD SHIPS AND SUBMARINES - PART 4: GENERAL NAVAL ENVIRONMENT CATEGORY 1
STANAG 4439 : 2010	POLICY FOR INTRODUCTION AND ASSESSMENT OF INSENSITIVE MUNITIONS (IM)
MIL STD 2105 : D	HAZARD ASSESSMENT TESTS FOR NON-NUCLEAR MUNITIONS
STANAG 4224 : 2007	LARGE CALIBRE ARTILLERY AND NAVAL GUN AMMUNITION GREATER THAN 40 MM, SAFETY AND SUITABILITY FOR SERVICE EVALUATION
AAS3P-1 : 2011	ALLIED AMMUNITION SAFETY AND SUITABILITY FOR SERVICE ASSESSMENT TESTING PUBLICATION - GUIDANCE
DEFSTAN 00-101(PT4)/2(2008) : 2008	DESIGN STANDARDS FOR EXPLOSIVES SAFETY IN MOD SHIPS AND SUBMARINES - PART 4: GENERIC NAVAL ENVIRONMENT
STANAG 4667 : 2011	GUN LAUNCHED GUIDED MUNITIONS, SAFETY AND SUITABILITY FOR SERVICE EVALUATION
AAS3P-11 : 2017	SAFETY AND SUITABILITY FOR SERVICE ASSESSMENT TESTING FOR SURFACE AND UNDERWATER LAUNCHED MUNITIONS
AOP 32 : 0	DEMOLITION MATERIEL - ASSESSMENT AND TESTING OF SAFETY AND SUITABILITY FOR SERVICE
AAS3P-10 : 2011	SAFETY AND SUITABILITY FOR SERVICE ASSESSMENT TESTING FOR SHOULDER LAUNCHED MUNITIONS
STANAG 4599 : 2007	WEAPON LAUNCHED GRENADE SYSTEMS, DESIGN SAFETY REQUIREMENTS AND SAFETY AND SUITABILITY FOR SERVICE EVALUATION
AOP 20 : 2017	SAFETY, ARMING AND FUNCTIONING SYSTEMS MANUAL OF TESTS

Standards Referencing This Book - (Show below) - (Hide below)

AOP 39 : 2010	GUIDANCE ON THE ASSESSMENT AND DEVELOPMENT OF INSENSITIVE MUNITIONS (IM)
STANAG 4439 : 2010	POLICY FOR INTRODUCTION AND ASSESSMENT OF INSENSITIVE MUNITIONS (IM)
AOP 38 : 2006	SPECIALIST GLOSSARY OF TERMS AND DEFINITIONS ON AMMUNITION SAFETY
STANAG 4123 : 0	METHODS TO DETERMINE AND CLASSIFY HAZARDS OF AMMUNITION

Add To Cart

Product Format

Quantity

add to cart