AS/NZS 4768.2:2003

Provides the test methods to be used for establishing compliance with the minimum radiofrequency requirements for operation of the equipment in Australian and New Zealand.

This part of IEC 60489 refers specifically to mobile radio transmitters and receivers for the transmission of data (telegraphy) signals having the emission characteristics given in 1.1.1.2. Emissions not covered by ITU Radio Regulations (edition 1982), Article 4 and Appendix 6 (AP6, Part A for details and definition of the emission characteristics) are not within the scope of this Standard. This standard is intended to be used in conjunction with IEC 60489-1. The terms and definitions and the conditions of measurement set forth in this standard are intended for type and acceptance tests. In Australia and New Zealand this Standard is intended to be used in conjunction with AS/NZS 4768.1. The object of this standard is to standardize the definitions, the conditions and the methods of measurement used to ascertain the radio-frequency performance of data and selective call equipment, thus making possible meaningful comparisons of the results of measurements made by different observers and on different equipment. This standard will cover the following types of data signals:– bit streams;– character strings;– messages;– selective calling.Selective calling differs from messages in their intended functions; it may be considered as data signals, analogous to messages transmitting only the information required to activate an alarm on one receiver or a group of receivers. The methods of measurements for the radio-frequency parameters are appropriate for the four types of data signals. To differentiate between the radio-frequency parameters (e.g. adjacent channel power, frequency error) measured in this standard from those in associated standards, the name of each parameter is followed by either “(bit stream)” or “(character string)” or “(message)” or “(selective calling)”. After each radio-frequency parameter the general term “(data)” is used. When each equipment is measured, the proper data type “(bit stream)” “(character string)” “(message)” or “(selective calling)” will be substituted for “(data)”.

First published as AS/NZS 4768.2:2003.Reconfirmed 2013. First published as AS/NZS 4768.2:2003.