Standard Specification for Commercial Steel (CS), Sheet and Strip, Carbon (0.16 Maximum to 0.25 Maximum Percent), Hot-Rolled

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

08-12-2022

Publisher

American Society for Testing and Materials

1.1This specification covers hot-rolled carbon steel (CS) sheet and strip, in coils and cut lengths, in which the maximum of the specified carbon range is over 0.15 and not over 0.25 % and the maximum of the specified manganese range is not over 0.90 %. This material is ordered to chemical composition.

1.2This specification is not applicable to the steels covered by Specification A635/A635M.

1.3The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	A 01
DocumentType	Standard
Pages	3
PublisherName	American Society for Testing and Materials
Status	Current
Supersedes	ASTM A 659/A659M : 2018

ASTM A 786/A786M : 2015 : R2021	Standard Specification for Hot-Rolled Carbon, Low-Alloy, High-Strength Low-Alloy, and Alloy Steel Floor Plates
ASTM A 568/A568M : 2019 : REV A	Standard Specification for Steel, Sheet, Carbon, Structural, and High-Strength, Low-Alloy, Hot-Rolled and Cold-Rolled, General Requirements for

ASTM E 527 : 2023	Standard Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)
ASTM E 527 : 2016	Standard Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)